1.
Two typical recipes for the preparation of cold SBR are shown in Table 1.3.
制造低温丁苯胶的两个典型配方示于表1．3。
2.
Steady State Simulation and Optimization of Low Temperature Styrene/butadiene Emulsion Polymerization Unit;
低温乳液聚合丁苯橡胶装置的稳态模拟与优化
3.
Real Time Optimization System Rebuilding and Model Study of Low-Temperature Styrene and Butadiene Emulsion Polymerization;
低温乳聚丁苯橡胶实时优化系统构造及模型研究
4.
Development Situation of butyl - benzene rubber and butyl - benzene emulsion;
丁苯橡胶和丁苯胶乳的国内发展概况
5.
The effects of disproportionated potassium rosinate on the polymerization of cold ESBR and the stability of the latex were studied.
研究了以歧化松香酸钾皂作为主乳化剂时,对低温乳液聚合丁苯橡胶的聚合及胶乳稳定性的影响。
6.
NBR rubber O-rings provide trouble-free operation at standard temperature ranges. For high and low temperature applications Viton or Silicone.
在常温工作条件下使用丁腈橡胶，在高温或低温时采用氟橡胶或硅橡胶。
7.
THE REIATIONSHIP BETWEEN SEQUENTIAL STRUCTURE OF SOLUTION SBR AND ITS GLASS TRANSITION TEMPERATURE AND MECHANICAL PROPERTIES
溶聚丁苯橡胶的序列结构及玻璃化温度与力学性能关系的研究
8.
The shredded tire is shown a good sorbent by which phenol can be reduced hugely as a result of adsorption (the phenol remove ratios ranged from 70% to 83.19%).
苯酚浓度低、温度高、胶粒粒径小及胶粒添加量大，均对胶粒吸附去除苯酚有利。
9.
degumming at low temperature
低温脱胶,低温精练
10.
Common type: nitrile butadiene oil resistant rubber. Fluoroelastomer and silicon rubber are used in applicable situation of high and low temperature. Use relevant lubricant.
普通型：丁晴耐油橡胶。高温，低温的应用场合，使用氟橡胶和硅橡胶。使用相应的润滑剂。
11.
Study on the properties of NBR/SBR blend
丁腈橡胶与丁苯橡胶共混胶的性能研究
12.
Modification of styrene degassing tower in styrene butadiene rubber production
丁苯橡胶生产中苯乙烯脱气塔的改造
13.
testing method for synthetic rubber sbr
合成橡胶丁苯橡胶试验方法
14.
testing methods for synthetic rubber sbr latex
合成橡胶丁苯乳胶的试验方法
15.
testing method for extrudability of sbr and nbr unvulcanized rubber compounds
非硫化丁苯橡胶和丁腈橡胶的可挤出性的测定
16.
Comparison on analysis of energy saving of condensation systems for cis-1,4-polybutadiene rubber and solution polymerized butadiene-styrene rubber
顺丁橡胶与溶聚丁苯橡胶凝聚系统的节能取向
17.
Study on Blend of Styrene Block Copolymers/Styrene-butadiene Rubber/polychloroprene;
苯乙烯类嵌段共聚物/丁苯橡胶/氯丁橡胶共混物的研究
18.
Through vulcanization curves evaluation ammonium benzoate was selected as the vulcanizing agent of epoxy acrylate rubber (EACM).
通过硫化曲线评定，选用苯甲酸铵作硫化剂对环氧型丙烯酸酯橡胶低温胶进行硫化。