1.
The Designing and Technology of High-frequency Inducing Brazing Equipment for End Cap of Electromagnetic Change Valve
电磁换向阀端盖高频感应钎焊设备研制及工艺探讨
2.
Test ports shall have internal check valve and be equipped with caps.
测试端口应该内置止回阀并配置阀盖。
3.
Remove the service valves and cap the compressor ports.
卸去维修阀门，并盖住压缩机端口。
4.
Place the cover onto the spring with the internal guide on the cover positioned inside the end coil.
将阀盖及阀盖上的内部引导放置在弹簧上，定位内部端线圈。
5.
Add protective cap over electrical connector, set suction lever to full open.
把联线端的保护帽盖上，把吸引阀开到最大位置。
6.
Remove the relief valve cover bolts while holding the cover down.
边压住阀盖，边拆卸安全阀阀盖螺栓。
7.
Install valve cover (refer to valve cover installation in this section).
安装阀盖（请参阅本节中的阀盖安装）。
8.
Remove the relief valve cover, stem/diaphragm assembly, and relief valve spring.
拆卸安全阀阀盖，阀杆/隔膜总成，和安全阀弹簧。
9.
MATERIAL AND SERVICE– Cast steel bolted bonnet valves are available in a variety of body/ bonnet materials and trims.
材料和应用–铸钢螺栓阀盖阀门可配置多种阀体/盖材料和阀内件。
10.
Pacific cast steel bolted bonnet valves are supplied in a wide range of body/ bonnet materials and trims.
美国太平洋铸钢螺栓阀盖阀门可以配置多种阀体/盖材料和阀内件。
11.
Tag location for gate and globe valves is typically on the valve yoke or body/bonnet flange.
闸阀和截止阀的标签位置通常在阀门轭架或阀体/阀盖法兰上。
12.
bellows seal bonnet
波纹管密封型上阀盖
13.
Clean all carbon deposits from the combustion chambers, valve ports, valve stems, valve stem guides and hea
从燃烧室、阀口、阀杆、阀导管和盖清洁所有的积碳。
14.
Make sure you apply pressure to the cover as you lift it straight off.
确保在将阀盖笔直提起的同时有压住阀盖。
15.
Install relief valve cover nut and tighten.
安装安全阀阀盖螺母，并加以紧固。
16.
The stem and diaphragm assembly will normally remain with the cover as it is removed.
阀杆和隔膜总成通常附在阀盖上与阀盖一起拆离。
17.
The valve's seat is at the opposite end from the handle.
阀门的阀座位于手柄对面的另一端。
18.
The valves can used for pipe nozzle and have reliable performance.
阀门可用于管端作放空阀用，性能可靠。