1.
The design shall incorporate provisions that prevent moisture from wicking through the cable assembly even in the event the cable jacket has been punctured.
这种设计应该配置相关物品,以防止电缆外壳被刺穿后导致潮气侵入电缆组件。
2.
Coaxial with outside conductor terminated on chassis.
具有终接在机壳上的外部导体的同轴电缆。
3.
Aluminum-polyethylene primary covering used as the sheath for aerial cable.
用作高空电缆的外壳，主要材料是铝聚乙烯。
4.
Drag onto the page to add coaxial with outside conductor terminated on chassis.
拖到绘图页后，可以添加外部导体端接在机壳上的同轴电缆。
5.
The float is a chemical resistant polypropylene casing with a firmly bonded electrical cable protruding.
浮球采用抗化学物质腐蚀的聚丙烯外壳,配置坚固保护的电缆接头。
6.
The bending radius should not less than25 times of cable diameter.
电缆弯曲半径：不小于电缆外径的25倍。
7.
Protective coverings for electric cables-General
GB/T2952.1-1989电缆外护层总则
8.
Protective coverings for electric cables-Specific protective coverings for oil-filled cables with lead sheath
GB/T2952.4-1989电缆外护层铅套充油电缆特种外护层
9.
Protective coverings for electric cables-General protective coverings for cables with non-metallic sheath
GB/T2952.3-1989电缆外护层非金属套电缆通用外护层
10.
Protective coverings for electric cables-General protective coverings for cables with metallic sheath
GB/T2952.2-1989电缆外护层金属套电缆通用外护层
11.
For instance, you should make sure that the insulations between the soldering tweezers and welding cable are ok and the earthing point and each termipoint of soldering machine are in good condition.
如焊钳和焊接电缆的绝缘是否有损坏的地方，焊机的外壳接地和焊机的各接线点接触是否良好。
12.
"Allow enough excess wire inside the enclosure to make up connections to the appropriate line, load and control terminal block points."
在外壳内要保留足够的电缆长度,使其能够满足连接到负载和控制接头的所需适当长度的要求。
13.
Calculation of the laying-up diameter of LV power cables by the gradual degeneration method
两端极限法计算低压电力电缆成缆外径
14.
hank of cable
电缆盘, 一盘电缆
15.
This cable has a rubber casing.
这根电缆线外包有一层橡胶。
16.
insulating machine for electric cable (excl. gimping machines)
电缆绝缘层加工机（嵌心狭辫带机除外）
17.
RECENT ADVANCE IN FOREIGN WIREUNE LOGGING AND LOGGING WHILE DRILUNG TECHNOLOGY
国外电缆测井和随钻测井技术新进展
18.
For screened flexible cable, not less than6 times of cable diameter.
有屏蔽层结构的软电缆，应不小于电缆外径的6倍。