1.
A new processing method, gelation-flow-casting, specialized for the molding of polyvinyl fluorite (PVF) films, is introduced in this paper.
介绍了一种适合聚氟乙烯薄膜生产制造的新工艺―凝胶挤出流延法。
2.
Made of shaping Polytetrafluoethylene Resin with extrusion assistant by paste extrusion, press and stretch.
用聚四氟乙烯树脂、挤剂经糊膏挤出、延、燥和拉伸而成。
3.
The taxI amdelayed in the rush hour traffic.
出租车因高峰期交通拥挤而延误了时间。
4.
manually-adjustable flexible die lip. single manifold, multi-manifold co-extrusion cast film dies.
手动调节柔性模唇,单流道,多流道共挤复合流延薄膜模头。
5.
When you close your hand and press, some of the water gets out.
当你把手握紧挤压时，会流出一些水。
6.
Study on Three-Dimensional Flow of Coat-Hanger Die for Sheet Extrusion
板材挤出衣架式机头三维流场的研究
7.
THE FLOW ANALYSIS OF POLYMER MELT IN CO-EXTRUSION DIE
共挤出机头中的聚合物熔体流动分析
8.
The Stability of Two-Phase Flow Interface in Gas-Assisted Extrusion
气辅挤出成型中两相流界面的稳定性
9.
The Melt Rheological Behavior of m-LLDPE at High Speed Extrusion
m-LLDPE高速挤出流变性能研究
10.
On-Line Measurement and Control of the Flow in Precise Extrusion of Polymers
聚合物精密挤出过程中挤出流量的在线测量及控制方法
11.
Study on Structure-Properties-Processing of PA/EVOH Multilayer Co-Extruded Barrier Films
PA/EVOH多层共挤流延阻隔薄膜结构—性能—加工工艺研究
12.
Parametric Design and Flow Field Analysis of Pipe Die for Extrusion;
管材挤出机头流道参数化设计及流场分析
13.
Analysis of fluid field in wide sheet extruder die with both end feeding
两端进料式宽幅片材挤出机头流道流场分析
14.
The phenomenon of conduction delay in the outflow tract of ventriculus dexter of rabbit
兔右心室流出道兴奋传导的延迟现象
15.
Extruder and hual off adopt AC frequency conversion technology.
挤出机、引机等采用交流变频控制技术，调整方便。
16.
FEM Analysis in the Effect of Die Compression Section on Plastic Extrusion Flow
口模压缩段对塑料挤出流动影响的有限元分析
17.
Simulation of Flow Instability of Polymer in Extrusion Die
在挤出机口模中聚合物不稳定流动的模拟
18.
WALL SLIP PHENOMENON OF RUBBER COMPOUNDS IN EXTRUSION DIE FLOW
橡胶在挤出口型流动中的壁面滑移现象