1.
Roundwire snap rings for shaft
GB/T895.1-1986孔用钢丝挡圈
2.
A wide range of standard stampings, non-standard products, stainless steel washers, internal/ external teeth washers, rings, circlips for holes, circlips for shaft, other fasteners, fittings, seal washers and clamps主要生产各种标准件冲压件.各种非标产品.
不绣钢垫圈;内外齿垫圈;挡圈;孔用挡圈;轴用挡圈;纱嘴头,其他紧固件、接件密封垫圈卡圈.
3.
Specifications for ring-Round wire snap rings
GB/T959.2-1986挡圈技术条件--钢丝挡圈
4.
Circlips for holes--Type A
GB/T893.1-1986孔用弹性挡圈--A型
5.
Circlips for hole--Type B
GB/T893.2-1986孔用弹性挡圈--B型
6.
Research on the Drawing Technology of Tyre Bead Wires and Aperture Design of the Drawing Die
胎圈钢丝拉拔工艺和模具孔型设计研究
7.
Round wire circlips
GB/T921-1986钢丝锁圈
8.
Trapezed steel wire for spring washer
GB/T5222-1985弹簧垫圈用梯形钢丝
9.
Reason Analysis of Laying Fracture of Wire Rod C82DA for Steel Curtain
胎圈钢丝用盘条C82DA吐断问题原因分析
10.
The springs in seats and beds are made of coils of wire. The wire is springly and bends when pressed, but when the press is lifted.it springs back into position again.
座位和床上的弹簧是用钢丝圈制成，钢丝有弹性一压就弯，但是一没了压力，钢丝重新弹回去。
11.
nose ring for animals, of iron or steel wire
动物鼻圈,钢铁丝制
12.
cycle tyre bead ring flipper
力车轮胎钢丝圈包布
13.
Development of HTΦ0.96mm tempered bead wire
HTΦ0.96mm回火胎圈钢丝的开发
14.
Circlips for shaft--Type A
GB/T894.1-1986轴用弹性挡圈--A型
15.
The cold drawing wire prestressed concrete slab with circle hole is widely usedas a structure member.
冷拔钢丝预应力圆孔板是广泛使用的结构构件.
16.
The wire thread insert used in screw hole of the blade
关于钢丝螺套在削片机刀片螺孔中的应用
17.
fine mesh wire fabric reinforced concrete
细孔钢丝网增强混凝土
18.
Wire-o binding: A method of loose-leaf binding in which a continuous double loop of wire runs through punched slots along the binding side of a booklet.
双线圈装:用连续的双圈铁丝绕穿过打在书本订口的方孔而成的一种活页装。