1.
Influence of spline matching clearance on spline coupling failure;
试析配合间隙对花键联结失败的影响
2.
It presents an easy method to control the machining accuracy of thread with high requirement for fit clearance.
介绍配合间隙要求高的螺纹副的一种简易加工精度控制方法。
3.
The Effect of Integral Key Fit Clearance beyond the Tolerance of Rolling Mill Screw-down Motor on Service Performance of Rolling Mill
轧机压下丝杆花键配合间隙超差对轧机使用性能影响的分析
4.
combine ground clearance
联合收割机离地间隙
5.
Clutch pedal free travel
离合器踏板自由间隙
6.
Reasonable value of optimized negative clearance in fine-blanking with negative clearance
负间隙精密冲裁最佳负间隙的合理取值
7.
Impact of Gradation on Voidage of Rubber Asphalt Mixture
级配对橡胶沥青混合料空隙率的影响
8.
A Retrospective Research of Clinical Results of Anterior Cervical Discectomy and Fusion for the Treatment of Single-level Cervical Disease;
颈前路经椎间隙减压融合术治疗单间隙颈椎病的临床研究
9.
Gap Impedance Simulation of X-Band Three-Gap Coupled Cavity Output Circuit
X波段三间隙耦合腔型输出回路间隙阻抗的模拟计算
10.
Research on the Online Measurement System of Product Gesture and Aassembly Interval;
产品装配间隙及姿态在线测量系统的研究
11.
Experience Calculation for the Voids in the Mineral Aggregate (VMA) Based on Aggregate Gradation
基于矿料级配的矿料间隙率VMA经验计算法
12.
Analysis of Influence of Gradation and Testing Methods on Porosity of Coarse Aggregate
级配及测试方法对粗集料间隙率的影响分析
13.
lower high water interva
低高潮间隙低高潮间隙
14.
gap(p)ing of joints
连接间隙, 接缝间隙
15.
The Test Research on Critical Voids in the Minerals of Asphalt Mixture;
沥青混合料临界矿料间隙率试验研究
16.
Research on 3D Molding and Meshing Clearance of Conical Twin-Screw
锥双螺杆的三维建模与啮合间隙研究
17.
Modified SMA Design Procedure Based on Voids in Mineral Aggregate
基于矿料间隙率的SMA混合料设计新法
18.
The effects of five adjusting parameters of valve timing, admission valve clearance, emission valve clearance, rotational speed ,load rate are interacted.
配气相位、进气门间隙、排气门间隙、转速、负荷五个调整参数之间是相互影响的。