1.
Applying" Process Requirement", Reducing Unqualified Product;
实行《工艺纪律考核》 促进“降废减损”
2.
To detract from the authority, reputation, or prestige of.
减损（权势、声誉）使权势、声誉或地位降低
3.
Reduction on inclusion content in beam blank and reject ratio of large - size angle section
降低铸坯夹杂物含量减少大规格角钢废品
4.
A decrease or loss in value, as because of age, wear, or market conditions.
降价，减值由于老化、磨损或市场条件而造成价值上的减少或损失
5.
Metallographic technology can reduce the cost of rejects,and improve the product quality
运用金相技术,减少废品损失,提高产品质量
6.
Waste Reduction Plan [WRP]
减少废物计划〔减废计划〕
7.
Major Links of Loss Reduction and Energy Saving in Corn Post-harvest Circulation
玉米产后流通中减损降耗应关注的主要环节
8.
If the wire rope is rust or tear and wear, deduct the scrapping broken wires in Table16 according to Table18, and then scrap the wire rope according to the results.
钢丝绳有锈蚀或磨损时，应将表16报废断丝数按表18折减，并按折减后的断丝数报废。
9.
"detract:To undergo reduction in value, importance, or quality; become reduced, as in effect. Often used with from"
"贬低,减损:降低价值,重要性或质量;降低效果.经常与 from连用."
10.
Since output equals input minus losses, the engineer must kept the losses to a minimum.
因为输出等于输入减去损耗，工程师必须使损耗降低到最小。
11.
Only replacing the damage and deformation ciner in use, can reduce spillage of material thus lower its cost.
在使用损坏变形后，只需更换内衬，减少了材料损耗，降低了成本。
12.
In the first two months, the losses of loss-making enterprises dropped by 12 percent, 8.2 percentage points greater than the margin of decline in last year's same period.
1-2月份亏损企业亏损额同比下降12%，减亏幅度加大8.2个百分点。
13.
Integrated Process Research on Power/Material/Sludge Reduction of Large Wastewater Treatment Plant;
大型工业废水处理厂节能降耗减污集成新工艺研究
14.
Application Investigation on Vibration and Noise Reduction of Rubber Particle Asphalt Pavement Based on Wavelet Analysis
小波分析在废旧橡胶颗粒沥青混合料路面减振降噪中的应用研究
15.
Drop below
降低到……减至……
16.
Waste producers are encouraged to adopt clean technologies to minimise their wastes and so to cut their treatment costs.
当局鼓励废物产生者采用环保生产技术，尽量减少废物量，降低处理成本。
17.
This can be translated to lower die head pressure or lower mechanical tear and wear or higher extrusion productivity (up to 21 %) without compromising product quality.
这有助于降低口模压力 ,减少机械磨损或提高挤出生产率 (高达 2 1% )。
18.
Insulate your home. Cavity wall insulation can cut heat loss through the wall by up to 60 percent.
房屋隔热可以利用空心墙来减少热能损耗，降幅高达60%。