1.
As the lobe of the cam comes up under the cam follower, it pushes the cam follower upward (away from the camshaft).
当凸轮的凸角在凸轮挺杆下出现时，它推动凸轮挺杆向上运动(离开凸轮轴)。
2.
allowable pressure angle of cam mechanism
凸轮机构的许用压力角
3.
The camshaft has a cam, on which there is a lob, or bump.
凸轮轴上有一个凸轮，凸轮上有一个凸角。
4.
In this arrangement, the cam lobes push against round metal cylinders called cam follower.
在这种布置中，凸轮凸角推动凸轮挺杆。
5.
Study on the General Measuring Technique for Angle and Parameter of Cam;
角度及凸轮参数综合测试技术的研究
6.
Derivation of pressure angle formula for disk cam mechanism with convex arc bottomed follower
凸圆弧底从动件盘形凸轮机构压力角公式的推导
7.
overhead cam shaft
上凸轮轴上部凸轮轴
8.
Ferguson Cam Mechanism and the Design of Cam Surface
福开森凸轮机构及其凸轮轮廓曲面的设计
9.
Design and Analysis of Solution to Cam Initial Revolving Angle Test
凸轮测量起点转角求解方法的设计与分析
10.
Discussion on the Methods of Calculating the Pressure Angle of a Cam with Oscillating Follower Offset from the Axis
论偏置摆动从动件凸轮压力角的计算方法
11.
New Method of Founding Profile Equations and Pressure Angle Formula to the Cylindrical Cam Mechanism with Slide Roller-Follower
建立圆柱凸轮廓面方程及压力角公式的新方法
12.
Measurement of Rotation Angle and Intelligent Electronic Controller for Cam Operated Switches
旋转角的检测及智能化电子凸轮开关控制器
13.
The CAI Courseware of “the Pressure Angle of Cam” and Its Application;
“凸轮机构的压力角”CAI课件及其应用研究
14.
Each unit has a pair of cams, with an anti - friction roller for each cam.
每两对凸轮之间有一定的间隔,每一组凸轮中包括一对凸轮,每个凸轮对应一个减摩转子。
15.
As the camshaft rotates, the lobe, or high spot of the cam, pushes against parts connected to the stem of the valve.
当凸轮轴旋转时，凸轮凸起的或者高点的位置，推动气门座。
16.
Designing Cams Based on Solidworks Software and Cam s CNC Machining;
基于SolidWorks软件的凸轮设计和凸轮的数控加工
17.
As the camshaft continues to rotate, the high spot moves way from the valve mechanism.
因为凸轮轴继续旋转，凸轮轴上的凸起部分离开气门装置。
18.
Studies of the Conjugate Cams--The Several Mathematical Methods for the Equation of the Contour of the Conjugate Cams as well as the Calculation of the Pressure Angle
共轭凸轮研究——求共轭双凸轮廓线方程的几种数学方法以及压力角的计算