1.
Valves in these classes are also available with spiral wound or ring joint gaskets when specified.
如果用户要求，这些压力等级的阀门也可提供螺旋盘绕或环连接垫圈。
2.
Flange gaskets are not interchangeable with other mechanical pipe couplings or flange gaskets.
法兰垫圈与其它机械管道连接器或法兰垫圈互换。
3.
Malleable cast iron pipe fittings--Type size--Parallel union gaskets
GB/T3289.39-1982可锻铸铁管路连接件型式尺寸平形活接头垫圈
4.
The male and female joint confines the gasket O.D and I.D.
这种外螺纹和内螺纹连接限制了垫圈的外径和内径。
5.
The circular male and female bonnet joint is self-aligning and encapsulates the gasket.
圆形外螺纹和内螺纹阀盖连接是自行对准调整并且封装的垫圈。
6.
When in place, the gasket will be seated and flush with the valve body ends.
放置好后，垫圈将与阀体连接端口一起固定和冲洗。
7.
Standard joint is a circular male and female configuration with a corrugated metal gasket.
标准连接是圆形外螺纹和内螺纹结构，配置波纹金属垫圈。
8.
A wide range of standard stampings, non-standard products, stainless steel washers, internal/ external teeth washers, rings, circlips for holes, circlips for shaft, other fasteners, fittings, seal washers and clamps主要生产各种标准件冲压件.各种非标产品.
不绣钢垫圈;内外齿垫圈;挡圈;孔用挡圈;轴用挡圈;纱嘴头,其他紧固件、接件密封垫圈卡圈.
9.
The ring joint is self-aligning; the gasket maybe reused unless it is physically damaged.
这种环连接可自行调整对准；除非出现物理损坏，否则垫圈可以重复使用。
10.
Neoprene grommet and complete epoxy encapsulation provide for a true non-wicking cable entry. An isolating cable chamber is not needed.
氯丁橡胶绝缘垫圈和全部环氧树脂密封，提供真正的无芯电缆连接。不需要另外配置绝缘电缆盒。
11.
Valves in these classes are also available with spiral wound gasket bonnet joints when specified.
如果用户要求，对于这些压力等级的阀门，我们也可以提供螺旋盘绕垫圈阀盖连接。
12.
"attach each leg to the bottom of the enclosure using the three nuts, bolts, and washers provided for each leg."
将每个支柱联结到外壳底部,对于每个支柱,采用三套螺母、螺栓和垫圈与外壳进行连接。
13.
Flared type tube fittings--Back-up washer
GB/T5652-1985扩口式管接头锁紧螺母垫圈
14.
Bite type tube fittings--Tipping washer
GB/T3762-1983卡套式管接头用尖角密封垫圈
15.
a ring for packing pistons or sealing a pipe joint.
填塞活塞或垫在导管接头的圈环。
16.
horse shoe washer
开口垫圈,马蹄形垫圈
17.
boiler band joining eye bolt
锅炉带圈连接眼螺栓
18.
With gasketed connections, the material of construction of the washer is important, both for compatibility with the gases in use and for its mechanical properties.
对于衬垫接头，垫圈的结构材料对于使用的气体的相容性和垫圈的机械性能都是很重要的。