1.
REACTION SHAFT SUPPORT SEAL RINGS.
从动轴支撑封印环。
2.
"The driving shaft causes the spider to rotate, and the other two trunnions of the spider cause the driven shaft to rotate."
主动轴使万向节十字轴转动,另外两个万向节十字头使从动轴转动。
3.
Worn reaction shaft support seal rings
磨损的从动轴支撑密封环
4.
The Front/Reverse switching mechanism was placed on the driving shaft, while the acceleration clutch was placed on the driven shaft.
前/后机械开关安装在驱动轴上，同时加速离合器安装在从动轴上。
5.
a dead axle on a carriage or wagon that has terminal spindles on which the wheel revolve.
马车上或货车上有车轮围着旋转的末端心轴的从动轴。
6.
Research on Digitization Similar Design About the Driven Shafts in the Reduction Gearboxes Based on SolidWorks
基于SolidWorks减速箱从动轴数字化相似设计的研究
7.
Rotary engine: Internal-combustion engine in which the combustion chambers and cylinders rotate with the driven shaft around a fixed control shaft to which pistons are attached.
旋转式发动机: 燃烧室、汽缸与从动轴一起围绕着连接活塞的固定控制轴旋转的内燃机。
8.
The reason of rupture of driven shaft of idler wheel for some factory is analyzed.
文章分析了某单位移动工位滚轮架从动轴的断裂原因。
9.
A short shaft that transmits motion from a motor to a machine, especially in an automobile.
传动轴，驱动半轴从马达传送动作给机器的短轴，尤指汽车
10.
The drive to a machine can be obtained from a shaft.
机器的动力可以从轴得到。
11.
a rotating shaft that transmits power from the engine to the point of application.
从发动机向应用点传送力量的转轴。
12.
Disconnect the vent hose from the axle shaft tube.
从主动轴管上断开通风管。
13.
Separate the rear universal joint from the transfer case yoke.
从传动箱轴轭上拆下后万向节。
14.
An Analysis on the Uniform Speed Circumrotation of Rigid Body;
从匀速圆周运动谈刚体的定轴匀速转动
15.
By comparing on the manufacturing technology of the sliding bearing in different works, a new manufacturing technology is given so as to improve on the gluey condition of babbit of the sliding bearing.
比较不同工厂滑动轴瓦的制造工艺，提出新的工艺，从而改善滑动轴瓦锡基轴承合金的粘合情况。
16.
Remove the lower insert from the bearing cap.
从轴承盖上拆去下轴瓦。
17.
Remove the floor console from the floor pan transmission tunnel.
从底板变速器-传动轴盖板中拆去底板支柱。
18.
New Technology of Twin Symmetry Roll Axial Rolling Passive Spiral Bevel Gears
对称双辊轴向轧制从动螺旋锥齿轮新工艺