1.
Valve Lash Adjuster
气门间隙调节器又称液压挺杆
2.
Slide Hydraulic Tappet Remover/Installer Tool C-4129-A through opening in cylinder head and seat tool firmly in the head of tappet.
将液压挺杆拆卸/安装工具C-4129-A滑入汽缸盖开口，在挺杆头内将工具安置牢固。
3.
Install the hydraulic valve tappets.
安装液压气门挺杆。
4.
Lift the ram and position the tappet (with the ball bearing) inside the tester cup.
举起压头，在测试杯中定位挺杆（带滚珠轴承）。
5.
bar actuated pressure vent
杆式驱动液压排出孔
6.
helical spline type actuator
带螺旋活塞杆的液压缸
7.
reel height hydraulic adjuster lever
拨禾轮高度液压调节杆
8.
remote operation cylinder lever
分置式液压油缸操纵杆
9.
Hydraulic bi-directional clamping fixture composed of hydraulic cylinder and toggle-lever reinforcement mechanism
基于液压缸的铰杆—杠杆增力双向夹紧液压夹具
10.
Structure Optimization for Hydrostatic Supporting Bush of Crank Shaft and Rod Type Hydraulic Motor
曲轴连杆式液压马达静压支承连杆瓦结构优化
11.
A Hydraulic-Mechanical Driving Press with Bi-bar Toggle-lever Force Amplifier in Series
铰杆-杠杆串联增力液压-机械复合传动压力机
12.
Roughness and Rod Speed for Influence of Hydraulic Reciprocating Rod Seals Leakage
粗糙度和杆速对液压往复杆式密封泄漏的影响
13.
Hydraulic Valve Tappet Removal/Installation Tool
液压阀推杆拆卸/安装工具
14.
Design and Research on Hydraulic Non-Circular Gear Roof Bolt Driller;
非圆齿轮式液压锚杆钻机的设计研究
15.
Research of the Single Pole Operating System of the Small-Scaled Hydraulic Excavator;
小型液压挖掘机单杆操作系统的研究
16.
Fragmentation Rebuild on Piston Rod of B690-1 Type Hydraulic Shaping Machine;
B690-1液压牛头刨床活塞杆断裂的修复
17.
Discussion on Work Speed of Dipper Stick of a Hydraulic Excavator
液压挖掘机斗杆作业速度问题的探讨
18.
Optimal Design of Four-bar Mechanism in Hydraulic Support Based on Scilab
基于Scilab的液压支架四连杆优化设计