1.
tap and die set
全套螺丝攻和螺丝板牙
2.
gas stocks and dies
煤气管螺丝板牙和扳手
3.
self opening die head
自动开合螺丝板牙切头
4.
pepe stock and dies
管子丝攻和螺丝钢板
5.
Remove the fender lower screws.
拆下挡泥板下螺丝。
6.
The enterprise shanghai tongsheng trade co., ltd. offers among other things Wall screws and Chipboard screws.
为您提供关于切削板螺栓或墙螺丝钉的信息。
7.
Remove Forcing Screw 6960-4, Step Plate 8140–2, and Threaded Adapter 8140-
拆下加固螺丝6960-4、踏板8140–2和螺纹接头8140-1。
8.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
9.
Install screws at the front of the quarter trim panel.
安装在三角饰板前部的螺丝。
10.
Remove the fender top, front and the rear screws.
拆下挡泥板顶部、前部和后部螺丝。
11.
Install all fender screws finger-tight.
安装时用手指拧紧所有的挡泥板螺丝。
12.
The blackboard was screwed down to the wall.
黑板是用螺丝拧在墙上的。
13.
Check drain valve to make sure that it is closed.
把四个前面板螺丝和两个顶部法兰上的螺丝卸下来。
14.
Insert and screw the mounting screws through the motherboard screw holes and into the standoffs.
再将螺丝分别锁定在固定主机板用的铜柱螺丝孔位置中。
15.
Loosen setscrew 1 in the oil shield plate, and remove oil shield plate 2.
请拧松防油板固定螺丝1 ，然后卸下防油板2。
16.
"Drill & tap for M16X2-1.38 Deep NPT,16 places for cover plate mounting screw"
钻孔,攻出一只M16X2-1.38深NPT螺纹,16处,该螺纹应与盖板固定螺丝配套
17.
Remove the screw that secures the right door sill trim and the right cowl side trim to the right door opening sill.
拆下固定右门梁饰板和右仪表板边上饰板于右门通路梁螺丝。
18.
Remove the cover plate of the relief valve by removing the four connecting screws.
通过拆卸四个连接螺丝来拆卸安全阀盖板。