1.
Tightening down on special tool will push wheel stud out of the hub and bearing assembly flangRemove lug nut from stud and remove wheel stud from flange.
上紧特殊工具，即可将车轮螺桩推出轮毂及轴承组件。自螺桩取下凸缘螺帽并自凸缘取出车轮螺桩。
2.
square collar-head set-bolt
方头凸缘端紧定螺栓
3.
Hexagon head tapping screws with collar
GB/T16824.1-1997六角凸缘自攻螺钉
4.
Radial ball bearings with flanged outer ring--Flange dimensions
GB/T7217-1987凸缘外圈向心球轴承凸缘尺寸
5.
Using a short piece of pipe and Holder 6958 to hold the pinion yoke, or pinion flange, remove the pinion nut and washer.
用短管和托架6958固定小齿轮轴轭或小齿轮凸缘，拆下小齿轮螺帽和垫圈。
6.
flange ,tin, for tubes or pipes
锡凸缘,用于大小管
7.
flange ,zinc, for tubes or pipes
锌凸缘,用于大小管
8.
Flanged coupling
GB/T5843-1986凸缘联轴器
9.
propeller shaft pinion flange
传动轴主动齿轮凸缘
10.
choke flange coupling
波导管扼流凸缘耦合
11.
flange crossing-transmission shaft universal joint
凸缘叉-传动轴万向节
12.
The cam may have three, four or six lobes.
该凸轮上有3个，4个或6个凸缘。
13.
Bowfront:Having an outward-curving front.
弓状前缘的:具有外凸曲线形前缘的。
14.
the raised helical rib going around a screw.
绕着螺丝的凸起的螺旋状的肋纹。
15.
cap-and-pin type insulator
帽盖穿心螺栓式绝缘子
16.
Force the seal onto door flangContinue rearward until it is seated on flange.
用力将密封压到车门凸缘上，继续向后压直至它固定到凸缘上。
17.
Install a new cam bolt, cam and new nut in the axlRe-align the reference marks.
在轴上安装新凸轮螺栓，凸轮和 新螺帽。重新校准参考标记。
18.
Loosen two setscrews 5 in top feed cam 4.
拧松上送布凸轮4和固定螺丝52个螺丝。