说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 最后产品
1.
Communicate with customers to determine the final product requirements.
与顾客沟通,确认最后产品要求。
2.
ultimate yield
(加工后产品的)最终收率
3.
The software was a successful follow-up to the original product.
软件是对最初产品成功的后续产品
4.
screwdriver job
ph.1. 螺丝起子工作(产品最后组件工作)
5.
life cycle management (of products)
产品从出厂到最后消费的管理
6.
Develop procedures to protect your products after final testing and inspection, and during product delivery.
制定最后测试和检查后及产品交付期间保护产品的程序。
7.
Total, final payment is always due before goods leave the production site.
最后的全部款项也应该在产品离开工厂后付清。
8.
The manufacturer shall arrange for the protection of the quality of product after final inspection and test.
制造业者于产品最终检验与测试后,应作适当安排以保护产品质量。
9.
Finally, we obtain the price scale of intermediate product.
最后,得出中间产品价格存在的区间范围的结论。
10.
He had finally convinced several customers of the advantages of his product.
他最后使一些顾客信服他的产品的优点。
11.
A Vendor-Managed Inventory Model for Deteriorating Items with Partial Backlogging;
部分短缺量拖后且考虑最终产品变质的VMI模型
12.
Packaging is the last and best chance to influence a prospect this side of the checkout counter. Arrange all your packaging messages in a' natural reading sequence.
包装业是产品流通的最后一道具有影响消费作用的关键。所以尽可能使包装最简明的说明产品。
13.
After passing through the regeneration section, the partially cooled liquid product moves on to the sixth and final major component of the system for final cooling.
经过回流段以后,没完全冷却的产品流向第六个设备,也是最后的主要组成部分进行最终冷却。
14.
The final or ultimate user of a computer system. The end user is the individual who uses the product after it has been fully developed and marketed.
计算机系统的最后的、本的使用着。最终用户是在产品开发完善和投入市场后的个体使用着。
15.
You are better off removing the scratch with the right products then taking the band-aid approach of masking the defect.
去除划痕最好的办法是使用正确的产品,然后在其表面做修补。
16.
Final approval will be made on the basis of a trial run of the coke to determine reliability and consistency of product.
最终的批准将基于货物试运行后的可靠性和产品的一致性作出。
17.
To make final small changes to improve hardware or software performance; to fine-tune a nearly complete product.
为改进软件或硬件性能,对产品进行最后定型之前的修饰和润色。
18.
The US is the most important destination for our electronics exports, followed by Malaysia.
美国是我国电子产品出口的最大市场,马来西亚仅排在之后;