1.
abrupt component
管路上流动截面有突变的部件
2.
On the Adiabatic Steady Flowing of Fluid in the Varying Cross - Section Horizontal Tube;
变截面水平管中流体绝热稳定流动讨论
3.
On the cross section of the die, the flow centre lies in the region where the flow resistance is lower, and the extrusion velocity is higher over there.
结果表明:口模截面上流动中心位于流动阻力较小的部分,而且这部分的流速较快;
4.
Effect of inflow angle on high Reynolds number flows in circular-sectioned 90° bends
入流角对圆截面90°弯管内高雷诺数流动的影响
5.
The float in the screenshot above has a small right margin.
上面浮动的截图有一个小的右边界。
6.
Numerical investigation of heat transfer and flow resistance in U-shaped variable cross-section channels with different rib heights
带肋变截面回转通道内流动与换热的数值模拟
7.
diversion dam: A Barrier across a stream Built to turn all or some of the water into a diversion.
分洪坝: 河流上建造的一个拦截物,使全部或部分河水改变流向。
8.
The dynamic model of the section-varying intelligent piezoelectric beams with surface-bonded piezoelectric element is developed and the natural frequencies are analyzed.
建立变截面智能压电梁的动态模型，分析表面粘贴压电元件的均质梁的固有频率。
9.
But we do not yet have a circuit-breaker design that can cut off the extraordinary current that would flow over a SuperCable.
但目前还没有设计出一种断路器，可截断在超级电缆上流动的超大电流。
10.
Based on the simulating result of FEM numerical experiment, this paper investigates the effect of local buckling on the hysteretic behavior of tubular columns under cyclic unaxial load.
根据有限元模拟的结果,分析了板件局部屈曲对方管截面柱拉压滞回性能的影响。
11.
Influence of structural parameters on fluid flow and heat transfer in microchannel with periodically changeable cross-sections
周期性变截面微通道结构参数对流体流动和传热的影响
12.
Development Study on Calculation Software for Large Cross-section Soft-bus Conductor Length in 1 000 kV UHV AC Substation
1000kV交流特高压变电站大截面软母线装配长度计算软件的开发研究
13.
A projecting part with an opening, as at the end of a hose, for regulating and directing a flow of fluid.
管嘴，喷嘴管子等物件的尾端的带有开口的突起部分，用于控制和引导水流
14.
Development of Optimization Engineering Software for Transformer Core Section
变压器铁心截面优化工程软件的开发
15.
Research on How to Improve Machining Precision of the Workpiece with Curve Surface
提高变截面零件数控加工精度的研究
16.
The Influence of Turbine Volute Section Changing Curve for Inner Flow and Outlet Parameters
蜗壳截面变化规律对蜗壳内流动及其出口参数的影响
17.
Friction losses across pipe elements for coal-water slurries with wall-slip behavior
具有壁面滑移特性的水煤浆流经局部管件的阻力特性
18.
Calculating Method of Time-Dependent Reliability of Existing Bending Structure with T-Shape Section Considering Resistance Deterioration
考虑抗力退化的T形截面既有受弯构件时变可靠度计算方法