1.
blowout preventer and spool
防喷器及其在井口上连接的法兰短节
2.
Attach the riser tensioners , choke and kill lines to the slip.
将隔水管张力器，压井及放喷管线连到伸缩节上。
3.
Analysis on subsea wellhead stability of surface BOP drilling system in deepwater operations
深水水上防喷器钻井系统水下井口稳定性分析
4.
Plug the flow regulator into the wall and attach the nebulizer.
将气流调节器插头接通墙上电源，并连接喷雾器。
5.
The seal connect should use in short connector between the heater and tank.
加热器和油罐间靠安装短节进行联接，加热器和短节的法兰间应加耐油石棉垫。
6.
A butterfly isolation valve cannot be installed directly to the valve inlet flange, as the disc will contact the orifice plate.
蝶阀隔离阀不能够直接安装在阀门进口法兰上，因为其阀瓣将会接触到节流板。
7.
Blowout Preventers:An CSD Evaluation;
油田井口防喷器产品用户满意度评价
8.
When drilling cluster wells on offshore drilling platform, thefollowing up problem of all kinds of cables and BOP controlling cables must be solved.
在海上钻井平台上钻丛式井时，必须解决各种电缆束和防喷器控制管缆的随动问题。
9.
End Connections– choice of flanged or socket ends for piping flexibility.
(3) 连接端口-根据连接管道的情况，可选择法兰或承插焊连接端口。
10.
Breaking Reason and Solution of the Connecting Bolts Used in the Ball Mill End Cover
球磨机端盖法兰连接螺栓的断裂原因及其解决
11.
Set the BOP stack on the stump and close the hydraulic connector, and then secure it.
将防喷器组吊坐到甲板试验桩上、关液压爪形连接器，并固定。
12.
General purpose rigid coaxial transmission lines and their associated flange connectors--Generic specification
GB/T6643-1986通用硬同轴传输线及其法兰连接器总规范
13.
Research on Ultimate Capacity of Cast Tubular Joints and Flange Connection;
考虑倒角系数铸钢节点及法兰连接的承载性能研究
14.
Finite Element Analysis for Ultimate Strength of the Multi-plannar Tubular Joints and Flanges on Power Transmission Towers
输电塔空间相贯节点及法兰连接的极限承载力有限元分析
15.
Place the tester adapter over the opening.
把试验器连接装置放在加油口上。
16.
Study of Cable Head Pulling Force Home-madeization and Horizontal Well Tractor Logging Technique
水平井拖拉器测井工艺及张力短节国产化的研究
17.
Development and Application of Blowout on-off Connector of Big Diameter Deep Well Oil Pump
新型大直径深井抽油泵防喷脱接器研制和应用
18.
I took the speakers from the monitor I dismantled. The plug and socket above the motherboard is the12 V supply to the monitor.
我从一个拆掉的显示器上拿到了一个扬声器。在主板上放的插口就是连接显示器的12V电源接口。