1.
lock nut of iron or stee
锁紧螺帽,防松螺帽,铁或钢制
2.
Align the bushing with the spring eye or shackle eye and tighten the nut at the socket wrench end of the threaded roTighten until the bushing is forced into the spring eye.
将衬套对准弹簧眼或U型钩眼，并在螺纹杆的套筒板手末端锁紧螺帽。锁紧直到衬套进入簧眼。
3.
reverse anchor jam nut
反向锁闭机构紧固螺帽
4.
Fuel Pump Module Locknut
燃油泵模组锁定螺帽
5.
Loosen the compression nut tool.
放松压紧螺帽工具。
6.
spring stop-nut locking fastener
弹簧防松螺母锁紧件
7.
Lock ring with scre
GB/T884-1986螺钉锁紧挡圈
8.
Position locknut over top of fuel pump module.
将锁定螺帽放在燃油泵模组上。
9.
Lock rings with screw and circlip
GB/T885-1986带锁圈的螺钉锁紧挡圈
10.
Screw thread shanks for thread forming screw--Metric coarse thread series
GB/T6559-1986自攻锁紧螺钉的螺杆粗牙普通螺纹系列
11.
Tighten glass track nuts to 6 N·m (in-lbs) torque.
拧紧玻璃轨道螺帽至6 N·m (in-lbs)扭力。
12.
Torquing Tie Rod End Attaching Nut
拧紧转向拉杆端接合螺帽
13.
Install the bushing by tightening the Long Nut.
通过扭紧长螺帽来安装衬套。
14.
Tighten wheel nuts until all are properly torqued, to eliminate brake distortion.
拧紧车轮螺帽直到所有螺帽都达到适当的扭力，以免刹车变形。
15.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
16.
Flared type tube fittings--Locknut
GB/T5649-1985扩口式管接头锁紧螺母
17.
Flared type tube fittings--Back-up washer
GB/T5652-1985扩口式管接头锁紧螺母垫圈
18.
" Prevailing torque type all-metal hexagon nuts, style 1"
GB/T6184-19861型全金属六角锁紧螺母