1.
fixed spark-gap modulator
固定间隙火花放电调制器
2.
triggered spark gap
触发放电器触发火花隙
3.
Study on volt-ampere properties in WEDM
电火花线切割加工中放电间隙伏安特性的研究
4.
Real-time Detection Method of Discharge Gap in WEDM Processing
电火花线切割加工中放电间隙状态的实时检测
5.
high frequency spark gap oscillator
高频电火花隙发生器
6.
Numerical Simulation of the debris distribution in Liquid-Solid Two-Phase Flow Field of High Speed Small Hole EDM drilling
高速电火花小孔加工放电间隙液固两相流场蚀除微粒分布数值模拟
7.
The Development of Discharge Gap Control System for Wire Electrical Discharge Machining with Slow-Travelling Speed;
慢走丝电火花线切割机间隙控制系统的研究
8.
Study of the WEDM Gap State Control System;
电火花线切割机间隙状态控制系统研究
9.
Research on Detection Technology of Gap Discharge Status Based on Floating Threshold for WEDM
电火花线切割浮动阈值间隙放电状态检测技术的研究
10.
gap adjusting safe brake
间隙可调式安全制动器
11.
Research on Two-path Sampling Circuit of the EDM Gap Voltage and Relevant Fuzzy Control System
电火花加工间隙电压双路采集电路及其模糊控制系统的研究
12.
lepel quenched spark-gap
盘形猝熄火花放电器
13.
spark discharge particle generator
火花放电粒子发生器
14.
Pease's electric tester
皮斯电火花闪点测定器
15.
Marx's type gap resistance rectifier
马克斯放电间隙式整流器
16.
electronically controlled spark generator
电子控制火花发生器
17.
"After cleaning, the gap should be adjusted by bending the outside electrode. The center electrode should never be bent, since this will Break the porcelain shell."
清洁后,再对火花塞间隙处的侧电极弯曲度进行调校。中心电极绝不能弯曲,否则会破坏陶瓷外壳。
18.
Gap Flow Research for Deep-Small Hole Drilling by EDM Based on Fluent Software
基于Fluent电火花深小孔加工间隙流场的研究