说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 额定安全工作压力值
1.
safety working pressure rating
额定安全工作压力值
2.
PRESSURE/ TEMPERATURE RATINGS FOR BRONZE PRESSURE RATED VALVES?
青铜额定压力阀门的压力/度额定值?
3.
PRESSURE/TEMPERATURE RATINGS FOR BRONZE PRESSURE RATED VALVES?
青铜额定压力阀门的压力/温度额定值?
4.
The soft-sealing gate valve should not be used on pipeline in which running pressure may be over the rated pressure.
软密封闸阀不应安装在使用压力可能超过其额定工作压力的管路上。
5.
Before operation, special consideration must be given to pressure limitations, system containment, purging requirements, etc., to determine if additional safety measures are required.
在操作前,必须对压力极限、系统容积、净化要求等专门考虑,以决定是否要求额外的安全措施。
6.
Must not be rated higher than the working pressure shown on the data plate of the water heater.
额定压力不能高于热水器参数板上显示的工作压力。
7.
The cast iron body is rated at 15 psig at saturated steam temperature 250 F.
当饱和蒸汽温度为250oF时,本款铸铁阀体安全阀额定压力为15 psig。
8.
Replace cap with the correct rating for the system.
按系统正确的额定值更换压力盖。
9.
The Study of Safety Assessment Engineering Method of the Pressure Piping Containing LOP Defect;
未焊透缺陷压力管道安全评定工程方法研究
10.
Evaluation of the Measurement Uncertainty for the Indication Error of the Normal Work Pressuremeter
一般工作用压力表示值误差不确定度评定
11.
Impact of Job Insecurity on Job Pressure,Job Satisfaction and Performance;
工作不安全感及其对工作压力感、工作满意感和绩效的影响
12.
Application of Pressure Testing During Pressure Vessel Safety Assessment
压力容器安全评定中压力试验的应用
13.
Marking of electrical equipment with ratings related to electrical supply-Safety requirements
GB17285-1998电气设备电源额定值的标记安全要求
14.
Each hot water space heating boiler shall be equipped with a pressure relief valve set to relieve below the maximum boiler working pressure.
每个热水供暖锅炉都必须配置压力安全阀,其设置的泄压压力必须小于锅炉的最大工作压力。
15.
burst safeguard
安全爆裂片(置于热辊的一端,当其夹层压力大于规定值时会破裂)
16.
Install a listed temperature-pressure relieve valve in the remaining fitting.
在剩下的螺纹接头上安装额定温度/水压的安全阀。
17.
Install a listed temperature-pressure relief valve in the opening on the side of the heater.
在热水器侧面的开口位置上安装额定温度/水压的安全阀。
18.
Use regulators and pressure-relief devices when connecting cylinders to piping circuits with lower pressure service ratings.
在把钢瓶连接倒较低额定工作压力的管道回路时,使用调整器和减压装置。