1.
EXAMPLE OF DESIGN OF FLOATABLE AND WITHDRAW TYPE DIE INCLUDING CAVITY DIE, CORE ROD AND DIE SLEEVE
阴模、芯棒和压模套均可浮动的拉下式压模设计实例
2.
The process selecting and die designing for thimble punching
筒套的冲压工艺方案选择及模具设计
3.
Study on Modeling of Hydraulic Looper Control System in Hot Rolling Mill
热连轧液压活套控制系统的建模研究
4.
Numerical Simulation on the Unidirectional Extruding Capacity of Downhole Casing
井下套管单向挤压承载能力数值模拟
5.
The bush of the middle frame is a main part of the machine to produce oxygen bottle in a high pressure container factory.
“中模架衬套”是高压容器厂生产氧气瓶设备的主要配套构件。
6.
Failure Analysis of Steel Rope Jacket Cold Stamping Die and Its Structural Finite Element Calculation
钢丝绳套冷压模具失效分析及结构有限元计算
7.
The Upsetting-backward Extrusion Numerical Simulation for Axle Shaft Sleeve Based on DEFORM;
基于DEFORM的半轴套管体镦粗-反挤压数值模拟
8.
Dynamic Simulation Analysis and Matching Process Study for Additional Flow Rate Method
附加流速法压井动态模拟分析与配套工艺研究
9.
Numerical simulation study on multiple ram extrusion of connecting sheath
接套体多向挤压成形工艺数值模拟研究
10.
Core-Pulling Structural Analysis and Hydraulic Core-Pulling Design for Bushing-Type Parts Die-Casting Die
衬套类零件压铸模抽芯结构分析及其液压抽芯设计
11.
FEM Study on the Cold Extrusion of the Starlike Inner Race and Mold Optimization and Fatigue Analysis;
星形套冷挤压成形有限元法研究及模具优化与疲劳分析
12.
Numerical Simulation of Large Dimension and Thin-wall Ceramic Cylinder Liner during Cold Isostatic Pressing;
大尺寸薄壁陶瓷缸套等静压成型过程的数值模拟研究
13.
Reliability Evaluaton of Low-Voltage Switchgear Based on FFTA;
基于模糊故障树分析方法的低压成套设备可靠性评估
14.
Summarize of Hydraulic Slip-Form Sets of Wall Constructing Art on Large-Diameter Shaft of High-Strength High Performance Concrete
大直径立井高强混凝土液压滑模套壁施工工艺简述
15.
NUMERICAL SIMULATION OF HEAT TRANSFER AND PRESSURE DROP AT SHELL-SIDE OF INCLINED-PIN-FIN TUBE HEAT EXCHANGER
斜针翅管套管换热器壳程传热与压降的数值模拟
16.
Finite element simulation research of vibrationbushings forging based on the thermal-mechanical coupling
基于热力耦合的减振轴套挤压成形有限元模拟研究
17.
Numerical Simulation of Fluid-Solid Coupling for Lubricating Oil Extrusion Process Between Cylinder and Piston with Micro-pits
凹坑表面活塞与缸套挤压润滑油的流固耦合数值模拟
18.
bearing cup inserter set
轴承杯全套压入工具