说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 停泵
1.
Pump Failure Waterhammer in Heating Networks and By-Pass Pipe Choosen Principle Analysis;
供热管网停泵水锤及水泵旁通管选择分析
2.
Theoretical Study on Dynamic Characteristics of Large Low-Head Pumping Stations during Suspending Period;
低扬程大型泵站停泵动态特性理论研究
3.
Check valve applied in descreasing water hammer pressure when the pump stops;
止回阀在减小停泵水锤压力中的应用
4.
Study on Dynamic Characteristics of Flap Valve during Suspending Period and Design of Computer-aided Analysis System;
拍门停泵动态特性研究及辅助分析系统的开发
5.
Numberical Simulation and Visualization Study on Water Hammer
停泵水锤数值模拟及其可视化技术的研究
6.
DIVISION OF VOLCANIC RESERVOIRS WITH MULTIPLE PUMPS STOPPING AND FRACTURING TREATMENT CONTROL,DAQING OILFIELD
大庆火山岩高停泵储层特征划分及施工控制
7.
Based on this study an optimal design and measures of water hammer protection have been established.
并根据暂态过程研究结果,提出了该取水泵站防止停泵水锤危害的优化设计方案及技术措施。
8.
The Research of Water Hammer Caused by Pump Failure in Yumenkou Water Supply Project;
山西省禹门口工业供水工程停泵水锤的数值模拟
9.
Please stop the pumps and disconnect the booster pipes during the inspection.
检查期间请停掉泵浦,拆掉升压管。
10.
Pump shut down large-scale accidents and countermeasures to prevent water hammer
大型泵组事故停机中水锤防护及对策
11.
In case of disuse for a long time, it is necessary to discharge the feed in the pump chamber completely and wash it with water or steam.
当泵处于长期停止工作时,应将泵腔内料液放净,并用水或蒸汽冲洗。
12.
The Emergency Processing Measures for Pump Units Outage at High Place Pump Station of Product Oil Pipeline
成品油管道高点泵站泵机组停运的应急处理措施
13.
Signals from pumps' built in thermal contacts and moisture sensors are also connected to the PLC. If problem of overheating or leakage is found, the pump will be stopped automatically.
剩余污泥泵内置的温度及渗漏保护讯号将接至PLC,如水泵发生超温及渗水,水泵自动停止。
14.
THE INFLUENCE TO THE SYSTEM IN PARALLEL SYSTEM WHILE A PUMP SHUT DOEN BECAUSE OF ACCIDENT
并联系统中某台泵事故停机对系统的影响
15.
RESEARCH ON THE PROPERTIES OF GROUND SOURCE HEAT PUMP DURING SUMMER ON THE DIFFERENCE OF RUN-STOP RATIO
不同开停比下地源热泵夏季工况运行性能研究
16.
Treatment measures for frequently start-up and stop of oil pump in hydraulic turbine governor
水轮机调速器油泵启、停频繁的处理措施
17.
Numerical Simulation of Dynamic Behavior with Rapid-drop Gate in Vertical Axial Pumping Station During Its Suspending Period;
快速闸门断流立式轴流泵站停机过渡过程数值模拟
18.
Design and Optimization on Startup and Shutdown Mode of 300 MW Unit with Turbine-driven Feed Pump
300MW机组启停过程中全程使用汽动给水泵的设计与优化