1.
straightaway stands
串列式盘条轧机机组
2.
Comprehensive Evaluation of Strength and Stiffness about Rolling Mill Main Drive System of Mandrel Mill Group;
连轧管机组轧机系统强度的综合评价
3.
Introduction to φ258 PQF continuous pipe rolling mill newly built at Tianjin Pipe (Group) Corp.
天钢φ258PQF连轧管机组介绍
4.
Experiment-rolling Pipeline Steel X60 in 2300 mm Hot-rolling Line of Benxi Iron & Steel(Group) Co.,Ltd.
本钢2300mm热轧机组试轧X60管线钢
5.
Application Practice of the Hot Rolling Lubrication in Tangshan Jianlong 800mm Finishing Mill
800mm精轧机组热轧润滑工艺应用实践
6.
Discussion on pass system of roughing mills of continuous bar or wire-rod mill
连续棒线材轧机粗轧机组孔型系统的探讨
7.
Vibration of Finishing Stands in Hot Strip Mill and Suppression Measure
热轧宽带钢精轧机组机架振动分析及抑制措施
8.
Analysis of Stiffness Measurement of Full-floating Mandrel Mill
全浮动芯棒连轧管机组的轧机刚度实测分析
9.
To press with a mangle.
轧压用轧布机来轧压
10.
combination blooming billet mil
初轧-轧坯联合轧机
11.
Detection and Analysis of the Piercing Mill of Φ100 Pipe Rolling Block
Φ100轧管机组穿孔机检测与分析
12.
The Analysis of Torsional Vibration of F_1 and F_4 of Bao Gang 2050 Hot Continuous Rolling Mill Units;
宝钢2050热连轧机组F_1、F_4机座扭振分析
13.
Study and Improvement of Mill Type of 1550 Tandem Cold Mill in Baosteel
宝钢1550UCMW冷连轧机组机型研究与改善
14.
a rolling mill consists of two parts: the mill stand and the driving device. a set of roils is held in a housing (or stand).
轧机由两部分组成:轧机机座和驱动装置。轧辊组安装在牌坊上(即机架上)。
15.
Based on the features of rough mill, two-lever interative algorithm is used to calculate the pass schedule of rough rolling.
根据粗轧机组自身的轧制特点,采用内外两层循环迭代的算法来分配粗轧机组的轧制规程。
16.
THE APPLICATION OF CONTROLLED-COOLING TECHNOLOGY FOR REINFORCED BAR TO CONTINUOUS ROLLING PROCESS
钢筋轧后控制冷却工艺在连轧机组的应用
17.
The Mathematical Model and Simulation Research of Hot Strip Steel Finshing Group;
带钢精轧机组热轧过程数学模型及仿真研究
18.
The Expert System's research on the Design of Hot-strip Tandem Finisher Group;
热带钢连轧精轧机组设计专家系统研究