1.
While setting the span and zero, please open the front lid. As the following figure shows.
在进行比率和零点调节时,必须打开前面的活动盖。调节孔如图3。
2.
To adjust(an instrument or a device) to zero value.
![点击朗读](/dictall/images/read.gif)
把…调到零点调整(仪器或设备)到零点
3.
From April to June, Germany's economic growth was expected to speed up and could show an increase of over 0.5% after seasonal adjustment as compared with the 1st quarter.
在四到六月期间,德国经济可望加速增长,经季节性调整后,可能较第一季增长百分之零点五以上。
4.
NUMERIC ZERO-POLE PLACEMENT SELF-TUNING ADJUSTER DISPERSED WITH δ-TRANSPOSITION AND ITS APLLICATION IN HYDRAULIC SYSTEM
应用δ变换的零极点配置数字自适应调节器及其在液压系统中的应用
5.
This station signs off the air at midnight.
![点击朗读](/dictall/images/read.gif)
这个电台在午夜零点停止播送节目。
6.
Zero velocities on the cylinder were satisfied at the node points.
![点击朗读](/dictall/images/read.gif)
圆柱上速度为零在节点上满足。
7.
The Critical Point Control for Quality of Fruit and Vegetable in Retail Link;
![点击朗读](/dictall/images/read.gif)
零售环节新鲜果蔬的质量关键点控制
8.
Design of RS485 Bus Node with Zero-latency Isolation Technology
![点击朗读](/dictall/images/read.gif)
零延时隔离技术的RS485总线节点设计
9.
automatic balancing circuit
![点击朗读](/dictall/images/read.gif)
自动平衡电路,自动零点调整电路
10.
current regulator contact bracket
![点击朗读](/dictall/images/read.gif)
电流调节器接角点托架
11.
available range of set-point adjustment
![点击朗读](/dictall/images/read.gif)
定点调节的有效范围
12.
With decimal point,span,range and digit zero setting function.
![点击朗读](/dictall/images/read.gif)
具有小数点设定、比率、量程及零点调整功能。
13.
A point or region of virtually zero amplitude in a periodic system.
![点击朗读](/dictall/images/read.gif)
波节在一周期体系中实为零振幅的点或区域
14.
An Enterprise Supply Chain Modeling Method Through Non-Zero-Sum Cooperative Games;
![点击朗读](/dictall/images/read.gif)
供应链节点企业的非零和合作博弈建模方法
15.
change the setting of a thermostat
![点击朗读](/dictall/images/read.gif)
改变自动调温器的调节点
16.
The degree of precision with which surfaces are adjusted or adapted to each other in a machine or collection of parts.
配合机器或组装零件表面相互调整或调节到的精确程度
17.
Zero adjustment function,forward adjust is forward biased,reverse adjust is reverse biased.
零点调整功能,顺时针调整可以偏负,逆时针调整可以偏正。
18.
Compatibility will require that the girder deflection at B be zero.
![点击朗读](/dictall/images/read.gif)
根据协调性的要求,梁在B点的挠度应为零。