1.
Specification of the steam converting valve for fossil power stations
GB10868-1989电站减温减压阀技术条件
2.
Pressure Reducing Valve, PRV
减压阀（俗名减压掣）
3.
Check the temperature-pressure relief valve to insure that the valve has not become incrusted with lime.
检查降温减压安全阀是否被石灰堵塞。
4.
Activate the T &P Valve to release any water in the piping.
打开降温减压安全阀释放管道内的任何水。
5.
Outlet temperature characteristics of pneumatic pressure-reducing valve for hydrogen vehicles
氢能源汽车车载气动减压阀出口温度特性研究
6.
General specification for pressure reducing valves
GB/T12244-1989减压阀一般要求
7.
secondary air injection relief valve
二次空气喷射减压阀
8.
Pilot-operated reducing valves
GB/T12246-1989先导式减压阀
9.
Characteristics of Icing in High Pressure Pneumatic Relief Valve with Slide Pilot
滑阀先导式高压气动减压阀结冰特性
10.
"When lifting lever of temperature/pressure relief valve, hot water will be released under pressure."
扳动降温减压安全阀把手,热水将在压力下释放出来。
11.
No relief valve is required where two pressure reducing valves are installed.
如果装上两个减压阀，就不需要安全阀。
12.
Manually operate the temperature and pressure relief valve at least once a year to make sure it is working properly.
每年至少手动操作降温减压安全阀一次，以确认是否工作正常。
13.
Important: Only a new temperature and pressure relief valve should be used with your water heater.
重要提示：您的热水器只能采用崭新的降温减压安全阀。
14.
Air filtering pressure reducing valve, solenoid valve, valve location feedback device, valve gate locator, quick exhaust valce.
空气过滤器减压阀，电磁阀，阀位反馈装置，阀门定位器,快速排气阀。
15.
The principles, features of elastic pressure-reducing valve proportional pressure-reducing valve and regulative proportional pressure-reducing valve which are used in high-rise building water system are discussed.
论述了弹簧式减压阀，比例式减压阀与可调比例式减压阀的原理、点及其在高层建筑中的应用。
16.
Clearance leakage in high pressure pneumatic relief valve with slide pilot
滑阀先导式高压气动减压阀间隙泄漏特性研究
17.
Analysis of Output-pressure-affecting Factors of Pressure Reducing Valve
溢流型减压阀输出压力影响因素分析
18.
The heat source must not directly heat the container valve since the valve, connection, and relief device components can be damaged by excessive temperatures.
由于过高的温度会损坏阀门、接头和减压装置组件，热源不能直接加热容器阀门。