说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 故障指示
1.
double fault indicator relay
复式故障指示继电器
2.
drop fault indicator relay
吊牌式故障指示继电器
3.
Add LED Light for work state and system failure indicator.
增设工作状态指示灯或系统故障指示灯。
4.
As with ATM, correlation of fault indications is required to determine responsibility for the fault.
像ATM一样,需要故障指示的相互关系来确定对故障的响应。
5.
Correlation of the fault indications is important to determine responsibility for the fault.
这些故障指示的相互关系对确定对这些故障的响应措施是很重要的。
6.
Analysis of Over-range Default in TB Aircraft Fuel Indication System
TB飞机燃油油量指示超限故障分析
7.
A Landing-gear Indicating System Obstacle Elimination of Boeing 737;
B737NG飞机一次起落架指示系统故障的排除
8.
Fault Analysis on Wrong Indication of Microcomputer Protector Used in Medium-Voltage Switch Cabinet
中压开关柜微机保护装置误指示故障分析
9.
The rcc package also maintains state and resource information and directs fault recovery actions.
rcc 包还会维护状态和资源信息并指示故障恢复要采取的操作。
10.
"Troubleshooting the printer. 1) If no lights are on, check the power cord; then press the Go button."
排除打印机的故障。1)如果没有任何指示灯打开,按执行按钮。
11.
NOTE: If the VTSS indicator lamp flashed, the system is operational and verifieIf not, there may be a problem with the system.
注意:如果VTTS指示器灯闪烁,系统工作正常〈之,系统可能存在故障。
12.
If the endpoints both see AIS/RDI indications, then the fault is in the middle of the network.
如果在两个端点上都见到了AIS/RDI指示,那么故障是在网络的中央。
13.
Alarm Indication Signal (AIS) and Remote Defect Indicator (RDI) OA&M cells report faults on ATM virtual connections.
警告指示信号(AIS)和远地缺点指示符(DRI)的OA&M信元报告ATM虚拟连接的故障。
14.
exponent register overflow fault
指数寄存器上溢故障
15.
exponent register underflow fault
指数寄存器下溢故障
16.
Fault-free Cycles Passing Through Prescribed Paths in Hypercubes with Faulty Vertices
具有点故障的超方体中经过指定路的无故障圈
17.
It has advantages of small volume、 light weight、 high efficiency、 wide voltage stabilizing range、 no waveform distorion etc.
全部产品设有过压(压)护、时(择)护和故障保护,电压双向指示,功能更完善、安全可靠。
18.
Provide on site start-up, punch down, commissioning, training, programming, and service as directed by the Supervisor.
按照主管的指示提供现场系统启动、统关闭、运行、训和产品故障排查和处理等服务。