1.
T3Manual Valve Lever Position Switch C3 Sense or Park/Neutral Position Switch Sense circuit.
＊＊Ｔ３＝手工阀门操纵杆位置开关Ｃ３感知或停车／空档位置开关感知电路
2.
remote operation cylinder lever
分置式液压油缸操纵杆
3.
switches,levers,etc by which a machine is operated or regulated
（机器的）操纵装置（如开关、操纵杆等）
4.
Illustrated below are some commonly accepted positions of the lever and weight.
下图是常见的、能够接受的操纵杆和压铁位置。
5.
The control stick of an aircraft.
操纵杆飞机的操纵杆
6.
manipulate the levers of a machine
操纵机器的杠杆 [操纵杆]
7.
either of two rods that link the steering gear to the front wheels.
连接操纵装置和前轮的两根杆子之一。
8.
a control panel, board, lever, etc
操纵盘、 板、 杆等.
9.
In computer graphics, a lever with at least two degrees of freedom that is used as an input device, normally as a locator.
在计算机制图中用的一种操纵杆,至少有两个自由度,用作输入装置,通常用作定位器。
10.
NIBCO swing check valves are available with an outside lever and weight. The lever and weight arrangement is used to maintain exterior control over disc movement.
尼伯科旋启式止回阀可配置外部操纵杆和压铁。操纵杆和压铁用于对阀瓣进行外部控制。
11.
The front sledge could be steered by a lever on the front of the frame.
前滑板可由位于机身前部的操纵杆控制。
12.
When you want to manoeuvre the main engine by the mechanical manoeuvring system, it is necessary to turn the handle to the“ emergency” position.
当你想要使用机械操纵系统操纵主机时，必须转动手柄到应急位置。
13.
When you want to manoeuvre the main engine by the pneumatic manoeuvring system, it is necessary to turn the handle to the“ normal” position.
当你想要通过气动操纵系统操纵主机时，必须转动手柄到正常位置。
14.
PRNODL LEVER POSITION
ＰＲＮＯＤＬ杆位置
15.
" Types,positions and performance requirements for controls of motorcycles"
GB/T15366-1994摩托车操纵装置的型式、位置及基本要求
16.
When a force is applied through the control rod to the control lever, the latter rotates through some angle θ.
当力通过操纵连杆作用于操纵杠杆时，操纵杠杆将转动一角度θ。
17.
a steady hand on the tiller;
操纵杆上坚定的手;
18.
sidestick priority
旁操纵杆使用优先权