1.
The Study and Application about Virtual Instruments Technology in TEE Function Measurement;
虚拟仪器技术在油泵支架总成功能测试中的研究与应用
2.
Main products: oil tank, oil tube, oiler support, oil pump, oil applying wheel etc.
产品主要结构：油箱、油管、安装支架、油泵总成及涂油轮等组成。
3.
LDP Pump Bracket Nuts/Bolts
LDP泵支架螺帽/螺栓
4.
Topology Optimization of a Power Train Mount Bracket With Multi Load Cases Constrains
动力总成悬置支架的多工况拓扑优化
5.
The Optimization Design for the Powertrain Mounting Bracket of Car JOYEAR
景逸汽车动力总成悬置支架的优化设计
6.
guide piston complement for fuel pump
喷油泵导向活塞总成
7.
The top end bracket shall be fitted with a stainless steel lifting bail and shall be capable of supporting the combined weight of the pump and motor.
顶部尾轴承架应该配置不锈钢吊环，应该能够支撑泵和电机的总重量的压力。
8.
The top end bracket shall be fitted with a lifting bail and shall be capable of supporting four (4) times the combined weight of the pump and motor.
顶部尾轴承架应该配置吊环，应该能够支撑泵和电机的总重量四（4）倍的压力。
9.
If equipped, attach the power steering pump and bracket.
如果配备，连接动力转向泵和支架。
10.
Mode and Finite Element Analysis of the Centrifugal Pump Bearing Bracket;
离心泵轴承支架的模态及有限元分析
11.
Discussion on the Hydraulic Parameters of Bearing Prong in Long-axial Pump for Deep Well;
长轴深井泵轴承支架水力参数的探讨
12.
The power-train mount bracket has been researched by topological optimization method.
采用结构拓扑优化方法，对动力总成悬置支架进行了优化。
13.
A Study on Topology Optimization of Powertrain Mount Bracket Based on Finite Element Technique
基于有限元技术的动力总成悬置支架拓扑优化的研究
14.
"The pump casing shall be suitably ribbed, have tangential discharge, and be reinforced to support the weight of the motor assembly."
泵壳应该有适当的肋骨,按切线方向排放,能够再加固以支撑电机总成的重量。
15.
Lower engine with lifting fixture while aligning engine support insulator assembly into sill bracket assembly.
用提升装置降下引擎，同时将引擎支座绝缘体总成对正，放入横梁托架总成内。
16.
Submersible Turbine Pump Unit and Its Multi-function Valve Assembly
潜油涡轮泵机组及其多功能阀体总成
17.
Design of the Hydraulic Power Support Control System Based on CAN Bus;
基于CAN总线液压支架控制系统的设计
18.
Install thrust support assembly.
安装侧推支撑总成。