1.
Install cylinder head, intake manifold, and exhaust manifold, refer to cylinder head installation in this section.
安装汽缸盖，进气歧管和排气管，请参阅本部分的汽缸盖安装。
2.
Spark plug M10X1 with flat seating and cylinder head housing
GB/T6784-1986M10×1平座火花塞及其气缸盖安装孔
3.
Install the engine cylinder head, push rods, rocker arms, bridges, pivots and engine cylinder head cover.
安装引擎汽缸盖、推杆、摇臂、桥、枢轴和引擎汽缸盖罩。
4.
Position the cylinder heads onto head gaskets and cylinder block.
将汽缸盖安置到汽缸盖罩垫和汽缸体上。
5.
Sometimes the camshaft is fitted directly into the cylinder head and operates on the valves without rockers.
有时，凸轮轴直接安装在气缸盖上并且不用摇臂控制阀门工作。
6.
Slide Hydraulic Tappet Remover/Installer Tool C-4129-A through opening in cylinder head and seat tool firmly in the head of tappet.
将液压挺杆拆卸/安装工具C-4129-A滑入汽缸盖开口，在挺杆头内将工具安置牢固。
7.
"In the other kind of valve mechanism for an engine, the valves are located in the cylinder Block instead of the head."
另一种气门机构的气门是装在气缸体上,而不是装在气缸盖上。
8.
Install valve cover (refer to valve cover installation in this section).
安装阀盖（请参阅本节中的阀盖安装）。
9.
The Improvement of Seal Steel Ball Press Process for Cylinder Head of Engine
发动机缸盖油道密封钢球压装工艺的改进
10.
The application of fastening technology in cylinder head assembly
拧紧技术在发动机汽缸盖装配中的应用
11.
Install the distributor cap and wiring.
安装分电盘盖和电线。
12.
Instrument Panel End Cap Remove/Install
仪表板端盖拆卸/安装
13.
Instrument Panel Top Cover Remove/Install
仪表板上盖的拆卸/安装
14.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
15.
Install Timing case cover (refer to the timing case cover installation in this section).
安装正时箱盖（请参阅本节中的正时箱盖的安装）。
16.
Install the serrated retainers at the ends of the cover.
在盖的末端安装蛇型固定装置。
17.
Install relief valve cover nut and tighten.
安装安全阀阀盖螺母，并加以紧固。
18.
"Finally, door, windows, truck lids, trim item and so on are add to complete the assembly."
最后,再装门、窗、车盖、装饰等,以完成全部安装工作。