1.
Profile design for stretch bending die of extrusions considering springback
考虑弯曲回弹的拉弯模外形设计方法
2.
Technical Research and Numerical Simulation of B299 Doorframes;
B299轿车门框拉弯工艺研究及数值模拟
3.
Experimental and Simulation Study on Discrete Die Stretch Bending Forming
离散模板料拉弯成形实验及数值模拟研究
4.
Based on Layered-Slipping Model for Bending Stress Analysis of Stay Cables
基于分层滑移模型的斜拉索弯曲应力分析
5.
The strip deformation of simulation model established in tension levelling
带材拉伸弯曲矫直变形仿真模型的建立
6.
Nonlinear finite element analysis of deep flexural beam strut-and-tie model
深受弯梁拉压杆模型的非线性有限元分析
7.
Design of Stretch Bending Trajectory Based on Finite Element Simulation for Three-dimensional Profile Parts
基于有限元模拟的三维型材拉弯轨迹设计
8.
An equivalent model of jaw's boundary condition in numerical simulation of stretch bending for extrusions
型材拉弯数值模拟夹钳边界条件的一种等效模型
9.
Determination of Raman Scattering Cross Section of O-H Bending Vibration of Liquid Water by Internal Standard Method
内标法确定水的O-H弯曲振动模的拉曼散射截面
10.
Research on the Application of Neural Network in the Model for Limiting Flexural Strain of Asphalt Mixture at Low Temperature
基于BP神经网络沥青混合料低温弯拉应变预测模型
11.
Out-Plane Buckling of Eccentrcally Tensile Members and Tapered Beam-Columns;
拉弯构件及变截面压弯构件弯扭失稳分析
12.
leading half axle
(拖拉机转弯时)前进半轴
13.
Eular crippling stress
(纵向弯曲)欧拉临界应力
14.
Nora leaned out of the window.
诺拉弯腰探身窗外。
15.
The results showed that the tensile strength, flexural strength and flexural modulus increased obviously with increase of amount of Mica.
结果表明,复合材料的拉伸强度、曲强度和弯曲模量随着云母用量的增加而提高。
16.
The theory, method and procedure for measurement of the bending loss of single-model quartz fiber by using fiber Bragg grating sensor are introduced.
阐述了利用布拉格光纤光栅传感器测量单模石英光纤弯曲损耗实验的原理、方法和步骤。
17.
NUMERICAL SIMULATION OF FAILURE PROCESS OF THREE-POINT BENDING CONCRETE BEAM CONSIDERING HETEROGENEITY OF TENSILE STRENGTH AND POST-PEAK SOFTENING CURVE
考虑抗拉强度及峰值后软化曲线非均质性的混凝土梁三点弯破坏过程数值模拟
18.
Cut across the Trafalgar Square and then turn leave .
穿过特拉法加广场,然后左转弯。