1.
Their preform moulds could be 2-cavity based and use a hot plate or hot runner design.
模具有用两腔的，采用热板/热流道设计。
2.
Knowledge Based Research on the Modeling Technology of Products and Application to Hot-Runner Design;
基于知识的产品建模技术及在热流道设计中的应用研究
3.
The Study on Design of Stack Mold with Hot Runner System and Its Functions;
叠式热流道模具设计及其功能的研究
4.
The design on hot runner control system based on single-chip
应用单片机的热流道控制系统的设计
5.
In-situ measurements of heat loss in thermal insulation of equipments and pipes-Heat flow meter apparatus
GB/T17357-1998设备及管道绝热层表面热损失现场测定热流计法
6.
Multi-cavity preform moulds do not use the cold runner design. An often-used design for the runners is hot plate design.
多腔的瓶坯模具都不采用冷流道的。较简单的流道是热板设计。
7.
The Technology of Aided Design and Applied Research for Hot Runner System in Injection Molding;
注塑模热流道辅助设计技术与应用研究
8.
Designing of the Hot Runner Injection Mould for Reducer Gear Part Based on UG
基于UG的减速器斜齿轮热流道注塑模具设计
9.
Design of Injection Mould with Wedge-shaped Plate Typing and Hot Runner System for Mineral Water Bottle Parison
楔形导板分型矿泉水瓶坯热流道注塑模设计
10.
Thermal analysis and design optimization for cooling passage of turbine blades
涡轮叶片转弯流道换热分析与优化设计
11.
The Design and Process Test for Injection Mold with Hot Runner for the Production of Nylon 1010 Caps
尼龙1010圆盒盖热流道注塑模热喷嘴的设计及工艺试验
12.
Sulphur Hexafluoride Transformer’s Directed-Gas Duct Design Based on Thermal-Fluid Coupled Field Analysis
六氟化硫变压器导向型气道的热流耦合场分析及设计
13.
Study of Design and Calcuation Method for Directly Buried Heating Pipe;
直埋供热管道设计及计算方法的研究
14.
Code for design of heat insulation engineering of industrial equipment and pipelines
工业设备及管道绝热工程设计规范
15.
Design Methods of Tee Branch of Directly Buried Heat-supply pipeline
直埋敷设供热管道三通支管设计方法
16.
The molding method,process,and the equipment of thermoset runnerless injection molding have been discussed in this paper.
论述了无流道热固性塑料注射成型的方法、工艺、设备和模具设计方面的问题。
17.
Abstract: The molding method,process,and the equipment of thermoset runnerless injection molding have been discussed in this paper.
文摘:论述了无流道热固性塑料注射成型的方法、工艺、设备和模具设计方面的问题。
18.
Numerical simulation on flow and heat transfer in channel with small spacing short pin-fin arrays
小间距梯形扰流柱通道内的流动换热数值计算