1.
shock absorber combustion head
减震燃烧(式)缸头
2.
piston to head clearance
活塞底和气缸头间隙
3.
New cylinder head bolts should be use
应使用新的汽缸头螺栓。
4.
Remove the engine cylinder head bolts.
拆卸引擎汽缸头螺栓。
5.
Remove manifold from the cylinder hea
从汽缸头拆下歧管。
6.
Place the engine cylinder head over the dowels.
将引擎汽缸头放在销上。
7.
Remove cylinder head cover, refer to cylinder head cover removal in this section.
拆下汽缸头盖，请参阅本节中的汽缸头盖的拆卸。
8.
Engine Cylinder Head Bolt Tightening Sequence
引擎汽缸头螺栓锁紧顺序
9.
Remove bolts, nuts and washers attaching manifold to cylinder hea
拆下系附在汽缸头的螺栓，螺帽和垫圈。
10.
Clean the exhaust manifold and cylinder head mating surfaces.
清洁排气歧管和汽缸头配合面。
11.
The cylinder head is heavily finned for strength.
汽缸头附有许多突片以增加强度。
12.
Remove control cables from cylinder head cover clip.
从汽缸头盖扣夹上移去控制拉索。
13.
Repeat the measurement with contacts lengthwise to engine cylinder hea
纵向接触到引擎汽缸头，重复测量。
14.
Tighten exhaust manifold to cylinder head bolts.
紧固排气岐管汽缸头螺栓。
15.
FINITE ELEMENT CONTACT ANALYSIS OF CYLINDER COVER AND CYLINDER HEAD BASED ON ABAQUS SOFTWARE
基于ABAQUS软件的液缸盖与液缸头接触有限元计算分析
16.
master cylinder outlet fitting gasket
主缸出油接头垫密片
17.
SR cylinder oil
直接蒸汽拔头汽缸油
18.
tension-control cylinder
控制钻头给进的液压缸