1.
main bearing aligning gauge
主轴承座孔同轴度检验仪
2.
Measures for improving the concentricity of the bearing s minor hole at the two ends;
提高套筒两端轴承档内孔同轴度的措施
3.
Analysis of the Precision Measure Method for the Bearing Seat Hole Center Distance in the Gear Box
齿轮箱轴承座孔的中心距测量方法精度分析
4.
Measurement of Dynamic Stresses and Temperatures of Main Bearing Walls and Caps on an Engine Block
发动机缸体主轴承座及主轴承盖的动态应力和温度测量
5.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
6.
plain bearing housing with bearings
装有轴承的普通轴承座
7.
housing bearing plain without bearings
未装轴承的普通轴承座
8.
Design of Roundness Automatic Measuring System for Bearing Hole of Diesel Engine
机车柴油机轴承孔的圆度自动检测系统设计
9.
Analysis of the cooperation with Cork Drum Shaft,Bearing housing and Ball Bearing on the Changcheng Cigarette|machine
长城机水松纸鼓轮轴和轴承座孔与轴承之间配合关系的分析
10.
bearing preload indicator
检验轴承预载示功器
11.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
12.
"When the two shafts are at an angle to each other, the bearings in the yokes permit the yokes to swing around on the trunnions with each revolution."
当两轴相互处在同一角度上,主动轴转动时万向节叉上的轴承使万向节叉绕万向节十字轴摆动。
13.
Analytical Investigation on Strength and Main Bearing Lubrication of CA4D32 Diesel Engine Crankshaft System Based on a Simulation Technique;
柴油机曲轴轴系强度和主轴承润滑仿真研究
14.
NSZD629 Automatic Measurement Instrument for Bearing Bore Diameter
NSZD629型轴承内径自动检测仪
15.
Using it to spray on axes and bore of bearing.
运用粉末复合电弧喷涂技术对轴类零件和轴承座内孔进行喷涂。
16.
Keywords: hard disk drive, slider bearing, flying height, simulation.
关键词：硬碟机、座轴承、行高度、值模拟。
17.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
18.
Crankshaft and main bearings service
曲轴和主轴承的维修