1.
Basic environmental testing procedures for electric and electronic products--Solderability testing by the wetting balance method
GB/T2423.32-1985电工电子产品基本环境试验规程润湿称量法可焊性试验方法
2.
Basic environmental testing procedures for electric and electronic products--Guidance on solderability testing by the wetting balance method
GB/T2424.21-1985电工电子产品基本环境试验规程润湿称量法可焊性试验导则
3.
Test methods of precious metal pastes used for thick-film microelectronics--Test of solderability and solderleaching resistance
GB/T17473.7-1998厚膜微电子技术用贵金属浆料测试方法可焊性、耐焊性试验
4.
Thermal Fatigue Reliability Analysis of High Speed Backplane Solder Joint Based on Orthogonal Experiment
基于正交试验法的高速背板焊点热疲劳可靠性分析
5.
Research on Microstructure and Property of Flux-cored Welding Wire Wear-resistant Overlay
药芯焊丝堆焊耐磨覆层组织性能试验研究
6.
A STUDY OF A.C. ARC STABILITY OF LOW-HYDROGEN BASIC ELECTRODES
碱性低氢电焊条交流稳弧性试验研究
7.
Welding Test of Cryogenic 3.5 Ni Steel Pipe;
低温用3.5Ni钢管的焊接性试验研究
8.
CTOD Fracture Toughness Test for Weld Seam of Q370qE of Bridge
桥梁钢Q370qE焊缝断裂韧性CTOD试验研究
9.
Test and Research on Welding Performance of T91 Refractory Steel Tube of Boiler
T91锅炉热强钢管焊接性能的试验研究
10.
Experimental Researches on the Welding Performance 9%Ni Steel of China
国产9%Ni钢焊接性能的试验研究
11.
Experimental research on gas metal arc welding of WNQ690 steel
高性能WNQ690钢气体保护焊试验研究
12.
Study on cold cracking susceptibility of domestic X80 pipeline steel using implant tests
国产X80钢焊接冷裂敏感性的插销试验
13.
Experimental Investigation of Weld on 321-Q370q Clad Plates
321-Q370q复合板焊接性能试验研究
14.
EXPERIMENTAL RESEARCH ON WELDING PROPERTY OF 14MnNbq STEEL THICK PLANK
14MnNbq厚板焊接性能试验研究
15.
Test method of solderability for printed boards
GB/T4677.10-1984印制板可焊性测试方法
16.
Welding tests showed the panel TIG welding machine can be applied successfully in hyperbaric conditions.
试验证明,该焊机可以成功地应用于高压环境下的焊接。
17.
The Microstructures, Properties and Welding Experiment of Welding Wires Prepared from Mg-Al Eutectic and AZ91D Magnesium Alloys;
Mg-Al共晶和AZ91D镁合金焊丝的制备、组织、性能及焊接试验
18.
Research on Microstructure and Property of Flux-cored Welding Wire Surfacing
药芯焊丝堆焊热作模具耐磨层组织性能试验研究