1.
Technical requirements for jerk fuel injection pump
GB/T5770-1997柴油机柱塞式喷油泵总成技术条件
2.
Main products: oil tank, oil tube, oiler support, oil pump, oil applying wheel etc.
产品主要结构：油箱、油管、安装支架、油泵总成及涂油轮等组成。
3.
Ningbo Shiguer electric fuel pump factory and specializes in car fittings enterprises.
宁波市江东实固尔汽配厂是一家专业生产电喷汽油泵以及各种车型的油泵总成的企业。
4.
guide piston complement for fuel pump
喷油泵导向活塞总成
5.
Submersible Turbine Pump Unit and Its Multi-function Valve Assembly
潜油涡轮泵机组及其多功能阀体总成
6.
The key to the technological transformation is the design of the manual oil pump、 the delivery pump and the whole transmission box.
技术改造的关键是手油泵、油泵及传动箱总成的设计。
7.
The Study and Application about Virtual Instruments Technology in TEE Function Measurement;
虚拟仪器技术在油泵支架总成功能测试中的研究与应用
8.
fuel oil priming pump
起动充油泵、起动燃油泵
9.
fuel-oil transfer pump
燃油输送泵，输油泵
10.
This system includes fuel oil tank, fuel oil pump, fuel oil hand pump, auxiliary engine daily service tank, piping and valves.
本系统由燃油舱、燃油驳运泵、燃油手摇泵、辅机日用油柜、管路及阀件等组成.
11.
Each senor group detects information, such as brake master cylinder pressure, steering torque, yaw rate, speed of each wheel, brake cylinder pressure of each wheel and throttle opening angle.
每个感应器组能探测到各种细微的信息，例如制动总泵油压、各个车轮的速率、制动泵油压等
12.
The Emergency Processing Measures for Pump Units Outage at High Place Pump Station of Product Oil Pipeline
成品油管道高点泵站泵机组停运的应急处理措施
13.
control and primary scavenging pump
控制泵和主动回油泵
14.
They are F. O. pumps， L. O. pumps, ballast pumps, fresh water pumps, sea water pumps, and bilge pumps.
它们是燃油泵，润滑油泵，压载水泵，淡水泵，海水泵，和舭部液舱泵等。
15.
OIL PUMP AND DISTRIBUTOR DRIVE GEAR INTEGRAL WITH CAMSHAFT
油泵及与凸轮轴集成的分电盘驱动齿轮
16.
Forming Technique Studies and Experimenta Verification for Sway Oil Pump Stator;
转向油泵定子成形工艺研究及实验验证
17.
Study on TiC/NiCrBSi Cladding Layers by Laser Cladding In-situ Fabricated on the Surface of Oil Well Pump Plunger
抽油泵柱塞表面激光合成TiC/NiCrBSi熔覆层研究
18.
Life cycle cost control and evaluation of underground screw oil pump
井下采油螺杆泵寿命周期成本的控制与评价