1.
wellbore storage depletion rate
井筒积聚流体的递减速率
2.
Application of polyocarboxy acid high performance water reducing agent to mass caisson of Taizhou Yangtze River Bridge
聚羧酸高性能减水剂在泰州长江大桥大体积沉井中的应用
3.
The transformed ferrite volume fraction increases and grain size decreases with the increase of cooling rate.
随着冷却速率的增加,铁素体体积分数减少,晶粒尺寸变细。
4.
Increasing Blasting Efficiency of Frozen Rock and Speedingup Shaft Construction
提高冻结基岩爆破效率 加快立井井筒施工速度
5.
Numerical Calculation of Flow Rate of Swabbed Fluid Flowing in Wellbore under Polymer-flooding Operating Mode;
聚驱工况下抽汲液在井筒中流动的流量数值计算
6.
A STUDY OF RHEOLOGICAL PROPERTIES OF MOLTEN POLYETHYLENE TEREPHTHALATE--Part Ⅱ:Rheological Properties of PET Melt at High Shear Rate
聚酯熔体流变性能的研究——高剪切速率下熔体的流变性能
7.
Under same conditions the deposition rate increased with the tube length and decreased with the flow velocity.
结果发现，在相同条件下，沈积率随管长增加而增大；随流体速度增加而减小。
8.
Under the declining-balance method, an accelerated depreciation rate is computed as a specified percentage of the straight-line depreciation rate.
使用双倍余额递减法时,加速折旧率计算为直线折旧率的一定比例。
9.
Deep Alluvium Mine Shaft Drilling Construction Method
深厚冲积层煤矿井筒钻井法施工的探讨
10.
Flow of Produced Fluid in Polymer Flooding Well with Pumping Rod Moving Axially--Theory, Calculation and Applications;
聚合物驱油井产出液在抽油杆做轴向运动的井筒中的流动——理论，计算和应用
11.
The application of Frequency Control on Steady Vehicles Group in Shaft Construction
稳车群变频调速在井筒施工中的应用
12.
Only later were the tissue isolates reduced to their minimum size to produce the maximum relative growth rates.
只有到后来，离体组织减少到它们的最小体积而产生最大的相对生长速率。
13.
Construction Practice on Rapid Driving through Silt Layer in Large-bore Vertical Shaft
大断面立井井筒快速通过砂土层的施工实践
14.
is the rate at which the balance declines. If factor is omitted, it is assumed to be 2 (the double- declining balance method)
指余额递减速率，若省略，则采用默认值2（双倍余额递减）．
15.
The Inertial Effects Due to the Fluid and Due to the Inner Bob in a Ca-Axial Rheometer
双筒流变仪中流体与内筒的惯性效应
16.
A new method on well bore hydraulic calculating of foam fluid
泡沫在井筒中流动的水力计算新方法
17.
Well injection rates in a particular area would initially be generally similar to pumping, offtake, rates.
对一个具体地段来说，井的注水速率开始时应当接近抽水速率。
18.
Design drive mechanism, such as gearbox, drum etc.
驱动机构的设计，如减速箱，卷筒等。