1.
Effects of intermediate principal stress parameter on deformation behavior of sands under cyclic rotation of principal stress axes
中主应力系数对应力主轴循环旋转条件下砂土变形特性的影响
2.
AN ELASTOPLASTIC CONSTITUTIVE MODEL OF SANDS CONSIDERING CYCLIC ROTATION OF PRINCIPAL STRESS AXES
考虑应力主轴循环旋转效应的砂土弹塑性本构模型
3.
EFFECTS OF PRINCIPAL-STRESS-AXIS ROTATION ON THE DEFORMATION OF A DAM UNDER WAVE LOADING
应力主轴旋转对波浪作用下堤防变形的影响分析
4.
Measuring and Analyzing the Residual Stress of the Principal Axis Bearing Racks of 1.5 MW Wind Power
1.5MW风机主轴轴承架残余应力的测量及分析
5.
Measurement of Dynamic Stresses and Temperatures of Main Bearing Walls and Caps on an Engine Block
发动机缸体主轴承座及主轴承盖的动态应力和温度测量
6.
Experimental Study on dynamic characteristics of saturated clay under cyclic rotation of principal stress directions
主应力轴旋转下饱和黏土动力特性的试验研究
7.
Experimental Study on Effect of Variation of Principal Stress Orientation on Intact Soft Clay
主应力轴旋转情况下原状软粘土应力应变试验研究
8.
True Triaxial Test of Medium Stress Influence on Duncan-Zhang Model
中主应力对邓肯-张模型影响的真三轴试验研究
9.
biaxial stress strain relation
双轴应力-应变关系
10.
The Local Plastic Stress and Strain Computation of Some Motor Shaft under Preheating Condition Based on ANSYS;
基于ANSYS的电机主轴预加热局部塑性应力应变计算
11.
Structure Optimization and Numerical Simulation of Stress and Strain Fields for the Main Shaft Device of a Hoist
提升机主轴装置结构应力应变场数值模拟及优化分析方法
12.
The clever use of neutro-axis of the girder in the stress measurement of the long span PC cable-stayed birdge
主梁中性轴在大跨度砼斜拉桥应力监测中的巧用
13.
The principal compressional stress axis obtaind through focal mechanism solutions show NNE and NW orientations.
由震源机制解求出的主压应力轴为北北东向和北西向。
14.
Rolling Bearing Stress Forecast System of Drive Rear Axle Main Speed Reducer;
汽车驱动桥主减速器圆锥滚动轴承应力预测系统
15.
uniaxial stress and temperature cycling test
单轴应力-温度循环试验
16.
The Application of Ceramic Bearing Electric Spindle on High-speed and Precise Grinding Machine;
陶瓷轴承电主轴在高速精密磨床中的应用
17.
Application of Oil Gas Lubrication Technique to Bearing of High-Speed Motorized Spindle
油气润滑技术在高速电主轴轴承上的应用
18.
Thus a normal loom has two shafts. The main shaft(crankshaft or top shaft) drives the lay mechanism and is geared to another shaft which operates at half of the speed of the crankshaft.
这样,普通织机应具备两根轴,主轴(曲拐轴或位于上部的轴)驱动筘座并通过齿轮驱动另一根轴。