1.
follower stud and unt
从动板柱螺栓及螺母
2.
studded-flange connection
带柱螺栓的法兰连接
3.
starter terminal stud
起动机线头接柱螺栓
4.
generator terminal stud insulator
发电机线头柱螺栓绝缘体
5.
junction block insulator terminal
接线块绝缘线头接柱螺栓
6.
double-screw bolt
螺柱，双头螺纹螺栓
7.
Mechanical property requirements for studs shall be the same as those for bolts.
柱头螺栓的机械性能要求与螺栓相同。
8.
" Bolts, screws and studs--Nominal lengths, and thread lengths for general purpose bolts"
GB/T3106-1982螺栓、螺钉和螺柱的公称长度和普通螺栓的螺纹长度
9.
" Mechanical properties of fasteners--Bolts, screws and studs"
GB/T3098.1-1982紧固件机械性能螺栓、螺钉和螺柱
10.
" Fasteners--General requirements for blots,screws,studs and nuts"
GB/T16938-1997紧固件螺栓、螺钉、螺柱和螺母通用技术条件
11.
" Fasteners--Bolts,screws,studs and nuts--Symbols and designations of dimensions"
GB/T5276-1985紧固件螺栓、螺钉、螺柱及螺母尺寸代号和标注
12.
" Mechanical properties of fasteners--Stainless steel bolts,screws, studs and nuts"
"GB/T3098.6-1986紧固件机械性能不锈钢螺栓,螺钉,螺柱和螺母"
13.
" Mechanical properties of fasteners--Bolts, screws, studs and nuts made of non-ferrous metals"
GB/T3098.10-1993紧固件机械性能有色金属制造的螺栓、螺钉、螺柱和螺母
14.
Bolt( screw, nut, stud, spring washer, pin, ball bearing, roller bearing) is the most commonly used machine part.
螺栓（钉、帽、头螺栓、簧垫圈、、珠轴承、柱轴承）最常用的机械零件。
15.
" Surface discontinuities of fasteners on bolts, screws and studs for general requirements"
GB/T5779.1-1986紧固件表面缺陷--螺栓、螺钉和螺柱--一般要求
16.
Surface discontinuities of fasteners on bolts screws and studs-Special requirements
GB/T5779.3-1986紧固件表面缺陷--螺栓、螺钉和螺柱--特殊要求
17.
377 bolt (screw, nut, stud, spring washer, pin, ball bearing, roller bearing) is the most commonly used machine part.
螺栓（螺钉、螺帽、双头螺栓、弹簧垫圈、销、滚珠轴承、滚柱轴承）是最常用的机械零件。
18.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"