1.
Prediction Model of Coating Thickness in Hot-Dip Galvanizing
带钢连续热镀锌层厚度预测模型研究
2.
Mass Calculation of coating (For equal coating)/MM
锌镀层质量(两个相同锌镀层厚度)
3.
Effect of Ni Content in Zn Bath on Thickness of Hot Dip Galvanized Coating
锌浴中镍含量对热浸锌镀层厚度的影响
4.
The required thickness of coating is obtained by the action of closed circuit control system above the molten zinc level (air knife).
通过气刀和镀层闭环控制系统对液态锌层厚度的调节使镀层厚度达到设定要求
5.
"To achieve good quality heavier coatings, srip roughness and pot chemistry must be appropriate for the combination of coating weight and line speed."
为取得良好的厚镀层,钢带粗糙度和锌锅内金属成分必须适应于镀层厚度及生产线速度。
6.
The Influence of the Temperature and Time on the Galvanized Coating;
浸镀温度和浸镀时间对热浸镀锌镀层组织的影响
7.
Base metal, application, JIS & ASTM standard, and Normal thickness of galvanized steel sheet
常用的镀锌钢片(电解片)的基层金属、用途、日工标准、美材标准及一般厚度
8.
A layer of hot-dipped galvanizing causes a considerable reduction in the fatigue strength.
热浸镀锌层引起疲劳强度的显著降低。
9.
multilayered plating thickness X-ray spectrofluorometer
多层镀厚度x射线荧光谱仪
10.
Beta backscattering thickness meter for small area of plating (coating)
GB/T10262-1988小面积镀(涂)层β反散射厚度计
11.
Effect of Chromium Plating Thickness on Fatigue Property of30CrMnSiA Steel
镀铬层厚度对30CrMnSiA钢疲劳性能的影响
12.
Relative quantifying technique to measure mass of fission plate in a fission chamber
裂变室镀层质量厚度的相对测量技术
13.
Based on this, coating thickness structure of tinplate was put forward and the concept of coating apparent thickness was defined.
在此基础上，建立了镀锡钢板镀层厚度结构模型，定义了镀层的表观厚度。
14.
Determination of Layers' Thickness and Bandwidth of Five-layer Transducer for PM AO Devices
PbMoO_4声光器件换能器五层镀层厚度和带宽的确定
15.
Research of Accelerated Corrosion Test of Zinc,CadmiumCoating on High-strength Steel
高强度钢表面镀锌、镉层加速腐蚀试验研究
16.
Effects of Drying Temperature on Phase Compositions and Properties of Mechanical Galvanizing Coatings
烘干温度对机械镀锌层物相组成和性能的影响
17.
at is concluded that by this process bright Zn plating can be provided with high deposition rate, low cost and reliable quality.
结论是本工艺可镀出全光亮的锌镀层、沉积速度快、成本低,质量稳定。
18.
Waveguide product plating thickness can be confirmed through surface effect depth.
通过趋肤深度,可以确定波导产品的镀层厚度。