1.
Influence of Structural Parameters of Air-cooling Platform on Heat Exchange Efficiency of the Air-cooling Unit
火电厂空冷平台结构参数对空冷单元换热的影响
2.
Numerical Investigation on the Heat Transfer and Fluid Flow of Wave-finned Tube and Air-cooled Condenser Unit
蛇形翅片管及空冷单元流动换热规律数值研究
3.
INFLUENCE OF INTERNAL FLOW GUIDING DEVICE UPON FLOW AND HEAT TRANSFER CHARACTERISTICS IN AIR-COOLED CONDENSER CELL
内部导流对空冷单元流动传热特性的影响
4.
Influence of Flow Guiding Device Upon Flow and Heat Transfer Characteristics of Air-cooled Condenser Cell
导流装置对直接空冷单元流动传热特性的影响
5.
Numerical Investigation of the Heat Transfer and Fluid Flow of Finned-tube and the Flow Characteristics of a Condenser Unit in Direct Air-cooled Power Plant;
电站直接空冷式翅片管换热和流动规律及空冷单元流场特性数值研究
6.
Vacuum Distillation Combining Vaporization and Condensation--Ⅲ.Separation of Aliphatic Alcohols
汽化与冷凝结合的真空蒸馏——Ⅲ.制取单元脂肪醇
7.
A Study of the Flow and Heat Transfer Performance of a Direct Air-cooled Condenser Sample Unit
直接空冷凝汽器单元样机流动和传热性能研究
8.
Research on Cooling Seasonal Total Energy Consumption Calculating Methods for Air-cooling Unitary Air Conditioner (Heat Pump)
风冷单元式空调(热泵)机组制冷季节耗电量计算方法的研究
9.
The constitution of the national standard of the energy efficiency for the unitary air - conditioner and water chiller has been introduced.
介绍我国单元式空调机和冷水机组国家能效标准的制定过程。
10.
Research on Flow and Heat Transfer of Finned Heat Exchanger of Direct-Cooled Condenser and Flow Characteristic of Condenser Unit;
直接空冷式凝汽器翅片散热器流动传热性能及单元流场特性研究
11.
terminal heating & cooling units
终端加热和冷却单元
12.
If the refrigerant system fails to reach the specified vacuum, the system has a leak that must be correcteSee Refrigerant System Leaks in this group.
如果冷媒系统失效未能达到指定的真空，系统存在必须修理的泄漏。请参阅本单元冷媒系统泄漏。
13.
Drain cooling system (refer to Group 7, Cooling System).
排干冷却系统（见单元7-冷却系统）。
14.
Merge blank cells with cell to the left
将空白单元格与其左侧的单元格合并
15.
The formula in this cell refers to cells that are currently empty.
此单元格内的公式引用了空单元格。
16.
Renstall the radiator and condenser unit in the vehiclRefer to Group Cooling System for the procedures.
重新安装散热器和冷却器单元到车辆上。程序，见单元7-冷却系统。
17.
Remove serpentine drive belt, refer to Group Cooling.
拆下蛇型驱动皮带，请参阅单元7-冷却。
18.
Fill in the blanks with the words and phrases you have learnt in this unit.
根据本单元学的单词和短语填空。