1.
Application of Fault Tree Analysis to Optimize Control System of Side Trimmer
应用故障树分析法优化切边剪控制系统
2.
The Research on Improving Thick Plates Shear Quality for Double Side Rolling Trimmer
改善厚板滚切式双边剪剪切质量的研究
3.
Improvement of Rolling-Cut Double Side Trimming Shear's Shearing Quality in Heavy Plate Mill of Baosteel
宝钢厚板厂滚切式双边剪剪切质量的改善
4.
Quality Control and Investigation of the Cold Strip Side Trimming
冷轧板带边部剪切质量的控制和研究
5.
Effect of Preloading on Shear Behavior of Saturated Loose Sand and Improvement of the Hypoplasticity-based Bounding Surface Constitutive Model;
预剪对饱和松砂剪切特性的影响及亚塑性边界面本构模型改进
6.
(botany) of the margin of a leaf shape; having the edge cut or fringed or scalloped.
（植物学）叶形边缘的；边部被剪切的、具流苏状的或具圆齿状的。
7.
rotary gang slitting
带材多刀圆盘剪纵剪切
8.
One that cuts, shears, or clips.
修剪工切、剪或削的人
9.
lawn trimmer and edger
草坪修剪-剪边两用机
10.
Mechanical shear components, the need for edge processing, shaving its capacity of not less than 2.0 mm.
气割或机械剪切的零件，需要进行边缘加工时，其刨削量不应少于2.0㎜.
11.
Precision-machined, bottom and top edges provide shearing action for pulp stock and slurry.
底部和顶部边缘经过精密机加工，对纸浆原料和浆液具有剪切作用。
12.
In that it is flat with little or no shear lips.
在这种情况下，它是平的带有较小的或者没有剪切边。
13.
The seismic source parameters of the 1991 Costa Rica aftershock sequence: evidence for a transcurrent plate boundary
1991年哥斯达黎加余震序列的震源参数:横向剪切板块边界的证据
14.
Study on In-situ Shearing Testing of Weak Joint Plane and Stability of Consequent Rock Slope;
顺层岩质边坡软弱结构面原位剪切试验及其稳定性分析研究
15.
Numerical analysis approach for stamping edge split of high strength steel considering sheared burr effect
考虑剪切毛刺影响的高强钢冲压边部破裂缺陷数值分析方法
16.
Experimental Research on Boundary Slip of Confined Liquids at Micro/nano Scale and Effect of Shear Rate
剪切率对微纳米间隙下流体边界滑移影响的试验研究
17.
Four-node quadrilateral element formation for laminated composite plates based on 1,2-3 higher-order shear deformation theory
基于1,2-3高阶剪切变形理论的四边形层合板单元列式
18.
Skipping an irregular paint application, usually occurring when improper contact is made between the applicator roll and the strip. See also starving out.
剪切—剪切还发生在辊与辊接触点。剪切通常还指金属剪切设备。