1.
Fracture analysis of the liner bolts used for φ5.03 m×6.4 m ball mill
Φ5.03 m×6.4 m球磨机端衬板螺栓断裂分析
2.
Install the bolts attaching the end cap to the front fender.
安装连接末端端盖到前挡泥板的螺栓。
3.
Reason Analysis of Bolt Breakdown Failure in Steel Ball Pulverizer Body and the Sheath Plate Reformation
钢球磨煤机筒体断螺栓原因分析及衬板改造
4.
shock absorber eye bolt sleeve
减震器有眼螺栓衬套
5.
Effect of End-plate to End- plate CFT- H Connection and Calculate Method of Bolt Tension
端板厚度对钢管混凝土端板梁柱节点的影响及螺栓力计算方法
6.
Research on Some Issues of Extended End-Plate Beam-to-Column Bolted Connections;
梁柱外伸端板螺栓连接中若干问题研究
7.
Research on the Performance of Steel Channels as Stiffeners in Bolted End-plate Beam-to-column Connections;
槽钢加劲肋在梁柱端板螺栓连接中的性能研究
8.
Extended End-plate Bolted Connections Performance Study of Steel Frame Structure;
钢结构梁柱外伸式端板螺栓连接节点性能研究
9.
Study on Behaviour of Extended End-Plate Joints under Load in Steel Structures;
钢结构螺栓端板连接节点的受力性能研究
10.
Analysis of the influence of prying force on connection design of end-plate's thickness
撬力对螺栓连接节点端板厚度设计影响的分析
11.
draw-bar carrier bolt
牵引杆托(板)螺栓
12.
follower stud and unt
从动板柱螺栓及螺母
13.
Pull back the wheelhouse liner and remove the bolts attaching the end cap to the front fender.
拉下舵手室外套，拆去连接末端端盖到前挡泥板的螺栓。
14.
Align the bushing with the spring eye or shackle eye and tighten the nut at the socket wrench end of the threaded roTighten until the bushing is forced into the spring eye.
将衬套对准弹簧眼或U型钩眼，并在螺纹杆的套筒板手末端锁紧螺帽。锁紧直到衬套进入簧眼。
15.
Remove rear lower suspension arm bolts.
拆卸后下端悬吊臂螺栓。
16.
square collar-head set-bolt
方头凸缘端紧定螺栓
17.
Research on the Mechanical Behaviors of Steel Frames with High-strength Bolts and Extended Endplate Considering Semi-rigid Connections;
半刚性高强螺栓外伸端板连接钢框架的受力性能研究
18.
Studies on Seismic Behavior of Through Column Bolted End Plate Beam-to-column Connections for Concrete-filled Square Steel Tube;
方钢管混凝土梁柱穿芯螺栓—端板连接节点抗震性能研究