1.
A cantilever bracket shown in Fig.3-1 might be quite helpful.
图三所示的的悬臂支架可能会很有帮助。
2.
A projecting frame extending laterally beyond the main structure of a vehicle, an aircraft, or a machine to stabilize the structure or support an extending part.
悬臂支架为使结构稳固或支撑外延部分而从车辆、飞机或机器的侧面延伸至主体之外的架子
3.
crane ,jib (excl. portal and pedestal cranes), self-propelled
自动悬臂起重机（门式臂架起重机及支座式悬臂起重机除外）
4.
Position the lower suspension arm at the axle bracket and rear bracket.
把下端悬吊臂放在车轴支架和后侧支架上。
5.
constructed of two cantilevers that meet in the middle.
悬臂自支架伸出，彼此相接而筑成的桥。
6.
Application of Bracket with Double-cantilevers Longitudinal Beam in 0# Block of Cantilever Perfusion Beam
牛腿双悬臂纵梁用于悬灌梁0#块支架的研究
7.
Most cantilever bridges have two arms of truss structure that meet or support a section between them.
大多数悬臂桥都有两个桁架臂用以对接或支撑两臂之间的桥段。
8.
Remove the upper suspension arm nut and bolt at the axle bracket.
从车轴支架上拆去上端悬吊臂螺帽和螺栓。
9.
Remove the lower suspension arm nut and bolt from the axle bracket.
从车轴支架上拆去下端悬吊臂螺帽和螺栓。
10.
The leaf spring mounted transversally does require additional Bracing; control arms and strut rods are therefore used.
在后悬架系统中,钢板弹簧横向悬挂,需有额外的支撑,因此要使用控制臂和横摆臂。
11.
knee-braced bracket
拐弯托座，膝形悬臂托架
12.
The swing arms are fastened to the inside structure of the mast, and permit the pipe rack to be low-ered from the stored position to the centerline of the drill string.
两个悬臂则固定在支架的内部结构上，并允许管架从贮存位置降到钻柱中线上。
13.
crane ,jib (excl. portal and pedestal cranes), not self-propelled
非自动悬臂起重机（门式臂起重机及支座式悬臂起重机除外）
14.
pylon diagonal drag brace
吊臂架交叉阻力支撑条
15.
folding arm lifting support
折叠臂杆式升降支架
16.
FEA of Lower Control Arm for Rear Double Wishbone Independent Suspension
后双横臂独立悬架的下控制臂有限元分析
17.
Control Arm Bushing To Suspension Cradle Retainer
控制臂衬套与悬吊架扣环
18.
Front axle Type Double arm independent suspensio
前桥型式双横臂独立悬架