1.
Analysis of hydraulic transient and transient condition test of pressure relief valve on long-distance pipeline
长输管道泄压阀水力瞬变分析及瞬变工况测试
2.
The Development of Measuring System for Asynchronous Motor s Operating State Based on Virtual Instrumentation Technology;
基于虚拟仪器技术的异步电机运行工况测试系统的研制
3.
Comparison between ECE R49 and ESC Test Cycles for Heavy-duty Vehicle Diesel Engine Emission Evaluation
评价重型车用柴油机排放的13工况测试循环和欧洲稳态测试循环的对比
4.
Research on Automobile Exhaust Measurement Mode Controlling System of VMAS195;
VMAS195汽车排放测试工况控制系统的研究
5.
Experimental Study on Indicator Diagram of Diesel Engine under Various Operating Conditions
多工况下内燃机示功图的试验测试与分析
6.
The result shows that this system is credible and stable and the parameters tested are accordant with the practical situation.
测试结果表明，该系统工作稳定、可靠，测试参数符合实际情况。
7.
A new methodology was developed to gain representative testing cycles from velocity versus time driving information.
研究重型车测试工况是一项重要的课题。
8.
The Design of Virtual Instrument Based on Embedded Linux for Testing Automobile Routine Parameters;
基于嵌入式Linux的汽车工况参数测试仪的研制
9.
Study and Experiment on the System of Inspecting and Surveying for Maize seeding-machine;
玉米播种机工况监测系统的研究与试验
10.
A Survey of the Physical and Health Conditions of Retired Teaching and Administrative Staff in Zhanjiang Normal College;
对湛江师院离退休教职工体质状况的测试分析
11.
Energy Test and Analysis of Double U-tubes Ground-source Heat Pump System in Variable Condition in Winter
变工况双U管土壤源热泵冬季能耗测试分析
12.
An Experimental Study on the Particulate Emission from Gasoline Vehicles Under Cycle Test Conditions
循环测量工况下汽油车颗粒物排放试验研究
13.
Performance Test for Plunger Pump and Hydraulic Cylinder Performed Under Special Working Conditions
特殊工况下柱塞泵和液压缸的性能测试
14.
The Research of Testing Method about AGC Cylinder of Simulating Friction Condition
AGC液压缸模拟工况摩擦力特性测试方法研究
15.
Inspection & Test Status Control Procedur
检查测试状况控制程序
16.
to test the working of a locomotive
测试机车运转情况。
17.
a place equipped with instruments etc for testing engines a machinery under working conditions.
一个装备有测试机器在工作状态时的情况的设备的地方。
18.
Commissioning tests shall be performed in the presence of the engineer or his representative.
测试生产检验必须在工程师或其代表在场的情况下进行。