说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 句库 -> 角位置误差
1.
Application of Recursive Least Square Method to Angular Error Checking
递推最小二乘法在角位置误差检定中的应用
2.
band of position
船位误差带位置线两侧)船位误差带
3.
Influence of turntable angular position reference errors on laser SINS calibration
转台角位置基准误差对激光捷联惯导标定的影响分析
4.
The paper describes the error analysis for this accuracy angular position transducer and the method for eliminating the error.
文中对这种高精度角位置传感器产生误差原因进行了分析,并给出了有效消除误差的方法。
5.
The Reflected Beam's Phase Aberration Induced by the Fabrication Errors of Corner Cube Retroreflector
角锥棱镜的误差引起的反射光束相位误差分析
6.
Analysis of Ideal Position in the Calculation of Positioning Errors;
关于定位误差计算中理想位置的分析
7.
The paper introduces the wind tunnel calibration method, items, data processing and calibration results for positional error of null-seeking differential pressure transducer.
本文介绍归零压差式攻角传感器位置误差风洞校测试验方法、目、据处理和校测结果。
8.
the error of a planet
行星观测上位置间的误差
9.
Measuring and Controlling the Position Error of Bearing Hole in Machining Canular Forked Shaft;
叉头套轴承孔位置误差的测量与控制
10.
Error Analysis of Axial Position and Measuring Equipment Design for NC Machine Tool
数控机床轴向位置误差分析及测量装置设计
11.
Using distant quasars as beacons, the antenna positions are triangulated for measurements within a centimeter, sometimes even within millimeters.
天线位置呈三角形,用远处的这些类星体做参考标志,测量误差可为厘米量级,有时甚至为毫米。
12.
The error in azimuth must be controlled by astronomical observations for azimuth(and longit ude).
方位误差必须观测天文方位角(及经度)来控制。
13.
The Calculation of Angular Error of Location on Condition of Arbitrary Edge Contact
定位销任意边接触时的角向定位误差计算
14.
The mechanical dial compartors are used for measuring the size deviation and position deviation of workpieces.
详细说明:杠杆齿轮比较仪用于测量工件形状误差和位置误差。
15.
On Dip Measurement Device that Controls Disturbance Accelerated Speed Errors;
抑制干扰加速度误差的倾角测量装置研究
16.
Error estimate of accuracy and its engineering treatment in elec-tro-hydraulic position servo system
电液位置伺服系统精度误差估计与工程处理
17.
The Analysis and Calculation for Design Site Error of Plate Cam Mechanism
盘形凸轮机构设计位置误差分析与计算
18.
Research on the Experiment and Compensation Technique of Position Errors for Economical CNC Machine Tools;
经济型数控机床位置误差的补偿及实验研究