1.
Approach to calibrating and compensating cogging force ripple in linear motors
直线电机齿槽推力波动的标定与补偿方法
2.
Study on the Slot Effect of Permanent Magnet Synchronous Linear Motors
永磁同步直线电机分数槽绕组谐波分析和齿槽力研究
3.
spline shaft
多槽[有齿, 花键]轴
4.
Comparison of a fixed fixed bridge with casting clasp retained nonextention removable partial denture
非游离端可摘义齿与固定义齿牙槽骨承力的变形分析
5.
SHEAR CAPACITY OF VERTICAL-GROOVED CONNECTION IN PBP STRUCTURES
装配式大板结构竖向齿槽接缝受剪承载力设计
6.
The cut mechanical model of pick-shaped cutter under conditions of dissymmetrical slotting
基于截槽非对称条件镐形截齿的截割力学模型
7.
Force behavior research on new Dry-Alveolus-Connection of precast reinforced concrete frame column
新型预制混凝土干式齿槽连接框架柱受力性能
8.
A small dent or nick, as in the body of a car.
小齿，槽口小齿或槽口，如在汽车车体中
9.
Study on the Bending Fatigue Stress Limit of the ZY-1 Case-hardened Double-circular-arc Gear and Its Form Factor Deducing;
ZY-1型硬齿面双圆弧齿轮弯曲疲劳极限应力研究及齿形系数推导
10.
However, their cogging torque or unbalanced radial force is usually high, deteriorating the machine performance.
但是这种电机的齿槽定位转矩或不对称径向力一般也比较高。
11.
Biomechanical Experimental Research on the Compression Plate of Gear Contact Plate-band and Channel Type for Femoral Fractures;
齿接触板-带式槽形加压钢板固定股骨骨折的生物力学实验研究
12.
Research on Cogging Torque Ripple Compensation at Low Speed for Direct Drive Ring Permanent Magnet Torque Motor
直接驱动环形永磁力矩电机低速齿槽转矩脉动补偿研究
13.
A Study on Characteristics of Air Static Pressure Thrust Bearing with Variable-Section Pressure Equalizing Groove
具有可变均压槽的气体静压推力轴承性能研究
14.
Treatment of Oil Spill From Thrust Groove in Erlangba Hydropower Station
二郎坝水电站发电机推力油槽溢油问题处理
15.
pronounce with a flap, of alveolar sounds.
发齿槽音时用节拍发出。
16.
The linkage rides to the end of the slot with enough force to break the choke valve away from the full-choke position.
连杆移动至槽的一端，用足够的力推动阻风门全部离开全阻风位置。
17.
Particle-In-Cell Simulation of the Influence of Conductive Groove on Near Wall Conductivity in Hall Thrusters
霍尔推力器传导沟槽对近壁传导影响的粒子模拟
18.
Make sure that the film stays within the film guides, and that the upper sprocket edge is under the guide plate.
要保证胶片嵌入胶片槽,且上齿边缘在槽板下。