1.
Exploration of the Two Flange Prefabricated Hole Diameter Calculation Formulas
翻边预制孔直径计算的两个公式的探究
2.
Circle flange forming by prefabricated elliptical hole in stainless steel elbow
不锈钢弯管上用预制椭圆孔翻边成形圆孔
3.
Numerical Simulation Research for Hole-flanging Based on DYNAFORM Software
基于DYNAFORM的圆孔翻边数值模拟研究
4.
A device to thicken edge of pre-punching hole on blank is also developed.
还研制了在板坯的预冲孔上增加边缘厚度用装置。
5.
the edge of both flaps was rolled up and the posterior flap was turned up into a "hook" or "barrette".
裂孔边缘特别是后瓣多翻卷形成钩状或发夹状。
6.
Effect of Additives on Properties of SiC Preforms
造孔剂对SiC多孔预制块性能的影响
7.
Operate guidebook:The direction key control run about, the blank space key inside out and square piece, want to walk while turn over.
操作指南：方向键控制行走，空格键翻转方块，要边走边翻哦。
8.
folded selvedge
卷边,翻边（织疵）
9.
Research on Formability of Aluminum Alloy Flanged Hole by EMF
基于磁脉冲技术的铝合金板材圆孔翻边工艺研究
10.
Loose plate steel pipe flanges with lapped pipe end for PN 1.0MPa (10 bar)
GB/T9122.2-1988PN1.0MPa(10bar)板式翻边松套钢制管法兰
11.
Loose plate steel pipe flanges with lapped pipe end for PN 0.6MPa (6 bar)
GB/T9122.1-1988PN0.6MPa(6bar)板式翻边松套钢制管法兰
12.
PASS DESIGN AND ROLLING OF NO.10/6.3 UNEQUAL-LEG ANGLE STEEL
10/6.3号不等边角钢的孔型设计与轧制
13.
Institute on The Hole Drill Technique of Bottom Chord Bar of Zhengzhou Yellow River Bridge
郑州黄河桥边桁下弦杆制孔工艺研究
14.
Beixiang beam line factory 32 m whole bore box beam preparing technique
北乡制梁场32m双线整孔箱梁预制技术
15.
EFFECT OF POROUS PREFORMS ON POROSITY OF PREPARED TiC/Ni_3Al COMPOSITES
多孔预制件对TiC/Ni_3Al复合材料孔隙率的影响
16.
Data prefetch optimization in dynamic binary translation
动态二进制翻译中数据预取优化研究
17.
Prefabrication Technology of Double-track Monolithic Box Girder in Wuhan-Guangzhou Passenger Special Line
武广客运专线双线整孔箱梁预制技术
18.
Numerical simulation and deforming control of concave curvature flanging in automobile panels
汽车覆盖件内凹圆弧翻边仿真与变形控制研究