1.
Research on Spindle's Strut Member of Numerical Control Electrical Discharge Machine;
数控电火花成型机床主轴支承系统的研究
2.
The spindle supporting structure of micropipette grinding apparatus eliminated the influence upon the end wobble of grinding plate effected by motor.
磨针仪主轴支承结构消除了电机对磨盘端面跳动的影响。
3.
Research on the Bearing and Seal Improvement Design in a Vertical Hydraulic Turbine Main Shaft and Its Application
一种立式水轮机主轴支承和密封改进设计的研究与应用
4.
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
5.
Active Control on Vibration of Multi-Disc Flexible Rotor System Mounted on Magnetic Bearing;
磁力轴承支承的多盘柔性转子系统主动控制
6.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
7.
pto bearing support
动力输出轴支持轴承
8.
The double direction angular contact thrust ball bearings are suitable for machine tool spindles , while the single are used to support ball screws .
双向推力角接触球轴承适用于机床主轴，单向推力角接触球轴承适用于丝杠支承。
9.
Fluid Simulating Analysis on Hydrostatic Bearing of High-speed Gear Shaper Spindle
高速插齿机主轴静压支承流体仿真分析
10.
Replacement and Treatment of the Main Bearing for the Gripper TBM during Driving
支撑式TBM掘进中途的主轴承更换及处理
11.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
12.
Crankshaft and main bearings service
曲轴和主轴承的维修
13.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
14.
The Model Analysis of the Ceramic Bearing Electric Spindle;
陶瓷轴承电主轴主轴的振动模态分析
15.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
16.
Most Bearings support rotating shafts against either transverse (radial) or thrust (axial) loads.
大多数轴承都支承径向或轴向负荷的转轴。
17.
Excessive friction in strut upper bearing
支柱上轴承磨损过度
18.
The carriage is supported on guide shafts.
托架支承在导轴上。