1.
Numerical simulation show that the results by CFM agree with those by FEM, and are much more accurate than those by PPM.
仿真结果表明 ,悬臂梁模型与有限元模型具有较高的一致性 ,它比简支梁模型更准确
2.
AN APPROXIMATE ANALYSIS FOR CALCULATION OF DYNAMIC PROPERTIES FOR DCB MODEL UNDER STEP LOADING
在阶跃载荷作用下双悬臂梁模型动态特性的近似分析法
3.
Keywords: micro-cantilever sensor, mechanical model, piezo-resistive materials, finite element method.
关键词：微悬臂梁感测器、学模型、阻材料、限元素法。
4.
Experimental Investigation of the Model and Analysis on Curvilinear Bridge with Boxed Cross-section;
曲线箱梁桥悬臂施工模型试验研究与分析
5.
The Fracture Reliability Model of Polycrystalline Silicon Microcantilever;
多晶硅微悬臂梁断裂失效的可靠性模型建立
6.
Studying the Mechanical Properties of Micro-Cantilever Beam Based on Neural Network
基于神经网络模型的微悬臂梁力学特性研究
7.
DAMAGE ASSESSMENT OF HELICOPTER BLADE BASED ON CANTILEVER BEAM DISPLACEMENT MODEL
基于悬臂梁位移模型的直升机桨叶损伤检测
8.
Simulations of piezoresistive microcantilever sensors for surface stress measurements
表面应力敏感型压阻微悬臂梁传感器的模拟
9.
Model Test for Cantilever Fish-bellied Thin-wall Steel Girder
大悬臂鱼腹式薄壁钢箱梁模型试验研究
10.
Theoretical Investigation on Natural Frequency of Electrorheological Material Based Adaptive Mortar Beam Structures Using Concentrated Compliance Method
基于集中柔度模型电流变体-砂浆悬臂梁固有频率的理论分析
11.
Forecast of Elevation of PC Cable-stayed Bridges Cantilever Construction Based on Error Correction Metabolic Model
基于灰色残差新陈代谢模型的悬臂施工主梁标高误差预测
12.
A Study on Space Numeric Simulation of Long Cantilever for PC Continuous Box Girder on Model Bridge
大悬臂预应力混凝土箱梁模型桥空间数值仿真研究
13.
A squeeze-film damping model for flexible cantilever microbeam under the effect of DC bias voltage
考虑直流偏置电压影响的弹性悬臂微梁挤压膜阻尼新模型
14.
Modal Analysis and Modeling of Micro Hard Disk Driver Suspension,Using ANSYS and Solidworks
用Solidworks和ANSYS对微硬盘悬臂梁进行建模及模态分析
15.
Algorithm Study on Active Control of Vibration in Flexible Cantilever Beam Based on Fuzzy Sliding Mode Control
模糊滑模控制的悬臂梁振动主动控制的研究
16.
Properties Research on a Large Annular Stadium Roof Structure with Cantilever Beam String;
大型环状悬臂型张弦梁挑蓬结构的性能研究
17.
Critical Lengths of Arc-shaped and S-shaped beams under the Action of Distributed Load
均布载荷下Arc型与S型悬臂梁的临界长度
18.
An Tunable Actively Mode Locked Fiber Ring Laser with a Cantilever Beam
主动锁模光纤环形激光器的悬臂梁调谐法