1.
Technical Innovation of SY-11CNC three spinning rollers numerical spinning machine
SY-11CNC三旋轮数控旋压机床的技术改造
2.
The Research of CNC Spinning Machine Alteration Based on Lathe C630;
基于C630车床数控旋压机床改造的研究
3.
Research on Automatic Programming System of the Special Spinning Machines for Vehicle Wheel's Hub;
车轮轮毂专用数控旋压机床自动编程系统的研究
4.
Rebuilding of CNC spinning machine based on C630 lathe
基于C630车床的数控旋压机改造
5.
Research on the Embedded Opening Numerical System in Belt-pulley Spinning Machine
皮带轮旋压机床用嵌入式开放性数控系统的研究
6.
Research on the NC System of a Two-Wheel Upright Spinning Machine;
立式两旋轮车轮辋旋压机数控系统研究
7.
Design and Realization of NC Grinding Machine Tool Control System for Rotary Burrs;
旋转锉数控刃磨机床控制系统的设计与实现
8.
Research on the Control and Testing Technologies of Numerical Control Electric Screw Presses
数控电动螺旋压力机控制与检测技术研究
9.
Relation between CNC Bevel Gear Generator Spatial Errors and Machine Setting Errors
螺旋锥齿轮数控磨齿机机床空间误差与机床调整参数的关系
10.
Compensation of Machining Errors of CNC Spiral Bevel Gear Grinding Machine
数控螺旋锥齿轮磨齿机机床加工误差补偿
11.
spin-forming and flow-forming machines
旋压成形机床和滚压成形机床
12.
Experimental Research on Frequency Conversion Hydraulics Power Unit of Numerical Control Machine Tool
数控机床变频液压动力单元试验研究
13.
Development of High Definition Numerical Control Machine Tool Hydraulic Function Units
高精度数控机床液压功能单元的研究
14.
Structural Design and Control System of Number Control Machine for Stranded Wires Helical Spring
多股螺旋弹簧数控机床结构设计及控制系统改进
15.
Items of Check before acceptance of NC metalforming equipment have been summarized via introduction to testing of varieties of accuracy of such machines.
通过介绍数控锻压机床各种精度指标的检测，总结了数控锻压机床的验收项目。
16.
Research on Machining Method and Special NC Equipment of Rotor Helical Convolute of Single Screw Compressor;
单螺杆压缩机转子螺旋面加工方法及专用数控装备研究
17.
Study on the Control of Step Motor in Rotary EMD Machine Tool
旋转电加工机床步进电机的控制研究
18.
Based on a5- axis NC grinding machine for rotary burrs developed by the Tianjin University, the4- axis NC grinding technology for rotary burrs is researched.
在天津大学研制的五坐标旋转锉刃磨机床的基础上，研究了旋转锉的四坐标数控刃磨技术。