1.
Optimization design and experimental model analysis of complex throttle injection with small apertures spray muffler
节流降压-小孔喷注消声器优化设计与模态分析
2.
A high-velocity fluid stream forced under pressure out of a small-diameter opening or nozzle.
喷射流体在压力迫使下从小喷嘴或小孔中喷出的高速流体
3.
The Effect of Oxygen Drop on Combustion Process Gas-Gas Injector
氧压降对气-气喷注器燃烧过程的影响
4.
Reduced pressure near the partially closed throttle valve caused the fuel to flow from the idling jet into the intake air.
由于部分关闭的节流阀附近的压力下降,燃油由怠速喷口喷入吸进的空气。
5.
Experimental Study on the Law of Jetting Boost Pressure in Hydrajetting
水力喷射孔内射流增压规律试验研究
6.
The Design of Orifice Compensated Hydrostatic Bearing on Over Loading Crankshaft of Oxygen Compressor
氧气压缩机重载荷曲轴用小孔节流静压轴承的设计
7.
Analysis of changes of pressure before the orifices in laterals under low pressure drip irrigation
低压滴灌小孔出流孔前压力变化研究
8.
However, caution must be exercised to avoid extremely close throttling when pressure drop exceeds20%.
但是，必须注意的是避免在压降超过20%情况下进行极端关闭节流。
9.
The density P is that of the fluid escaping from the orifice.
上式中p是从小孔喷出的流体密度。
10.
The high pressure rotating pile and punched cast-in-situ pile application in foundation pit support
高压旋喷桩+冲(钻)孔灌注桩在基坑中的应用
11.
Analysis of Orifice Compensated Mode Affecting Aerostatic Bearings Working Stiffness
小孔节流方式对气体静压轴承工作刚度影响的分析
12.
Analysis of Dynamic Characteristics of Aerostatic Bearing with Orifice Restrictors and Corresponding Rotor-Bearing System;
小孔节流静压气浮轴承—转子系统动力学特性研究
13.
Application of the high pressure circular jet grouting in the big dimension man-dig pile
高压旋喷注浆技术在大孔径挖孔桩施工中的应用
14.
Wellbore dynamic surge pressure while tripping a drill pipe in slim hole drilling
小井眼钻具升降产生的孔内波动压力
15.
Application of High-pressure Rotary Concrete-jetting Technology in the Reinforcement of the Bearing Layer of Rock-socketed Cast-in-place Pile Bottom
高压旋喷注浆法在钻孔灌注嵌岩桩底持力层补强加固中的应用
16.
A Numerical Simulation of Pressure-adjusting Devices of Complete Fluidic Sprinklers
全射流喷头压力调节装置流场数值模拟
17.
Research on Servo Valve Nozzle Eyelet Flow Character Measurement System;
伺服阀喷嘴小孔流量特性测量系统的研制
18.
Laminar pipe flow with Injection/suction through porous wall in the presence of a transverse magnetic field
具有抽吸/喷注的多孔壁圆柱管道内磁流体的流动